EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Fabrication and Contact Angle Prediction of Micro-Grooved Polymer Surfaces Using Micro-Injection Molding

Chaolan Zhou, Yiqin Hu, Fumin Chen, Yanjun Lu

Polymers · 19.11.2026 · 18 (22) · 2907

DOI: 10.3390/polym18222907 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 19.11.2026. Verfasst von Chaolan Zhou und 3 weiteren Autor:innen. Die Arbeit nennt 21 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Guangdong Basic and Applied Basic Research Foundation, Shenzhen Science and Technology Innovation Commission.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To optimize the hydrophobicity of polymer surfaces, micro-V-grooved polymer surfaces were fabricated in the study by replicating the micro-V-grooved array structures of a micro-ground titanium silicon carbide (Ti3SiC2) mold core through micro-injection molding. The effects of the micro-injection molding parameters, namely melt temperature, injection speed, holding pressure and holding time, on the replication rate and surface hydrophobicity were investigated, and the wetting behavior of the micro-V-grooved polymer surfaces was analyzed. The results showed that the melt temperature had the greatest effect on the surface hydrophobicity of the polymer, whereas the holding pressure had the strongest influence on the replication rate. The measured contact angles of the micro-structured surfaces were numerically closer to the values predicted by the Cassie model than to those predicted by the Wenzel model, which indicates that the Cassie model can serve as a first-order approximation for the contact angle of such surfaces. The largest contact measured on the micro-structured polymer surface was 132.20°, which was 188.58% higher than that of the smooth polymer surface.

Förderung

  • National Natural Science Foundation of China
  • Guangdong Basic and Applied Basic Research Foundation
  • Shenzhen Science and Technology Innovation Commission

Zitieren

APA

Zhou, C., Hu, Y., Chen, F., & Lu, Y. (2026). Fabrication and Contact Angle Prediction of Micro-Grooved Polymer Surfaces Using Micro-Injection Molding. Polymers, 18(22), 2907. https://doi.org/10.3390/polym18222907

Vancouver

Zhou C, Hu Y, Chen F, Lu Y. Fabrication and Contact Angle Prediction of Micro-Grooved Polymer Surfaces Using Micro-Injection Molding. Polymers. 2026;18(22):2907. doi:10.3390/polym18222907

BibTeX
@article{Zhou2026,
  author = {Zhou, Chaolan and Hu, Yiqin and Chen, Fumin and Lu, Yanjun},
  title = {Fabrication and Contact Angle Prediction of Micro-Grooved Polymer Surfaces Using Micro-Injection Molding},
  journal = {Polymers},
  year = {2026},
  volume = {18},
  number = {22},
  pages = {2907},
  doi = {10.3390/polym18222907}
}
Kostenlos starten →