EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Tensile and Structural Properties of Antioxidant- and CaCO3-Modified Polyethylene Films

Dmitry Myalenko, Olga Fedotova, Aleksandr Agarkov, Sergey Sirotin, Polina Poletaeva

Polymers · 09.08.2025 · 17 (16) · 2182

DOI: 10.3390/polym17162182 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 09.08.2025. Verfasst von Dmitry Myalenko und 4 weiteren Autor:innen. Beteiligte Einrichtung: All-Russian Dairy Research Institute (VNIMI), 115093 Moscow, Russia. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 70 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Education and Science of the Russian Federation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The demand for modified packaging materials increases annually. At the same time, there is growing interest in the development of functional packaging. The incorporation of modifiers, stabilizers, and fillers into polymer matrices can enhance the functionality of the material but may also negatively affect its safety. Polymers are susceptible to degradation, which negatively affects their strength and tensile properties under external factors (physical, chemical or environmental). Packaging containing antimicrobial and antioxidant agents is among the most promising, as it contributes to the product quality during storage. Films based on calcium carbonate (CaCO3) and dihydroquercetin (DHQ) remain insufficiently studied, despite their potential. Such materials are especially relevant for fatty products with a large contact surface area, including butter, cheese, and other solid high-fat foods. This study aimed to comprehensively investigate the structural and tensile properties of polyethylene films modified with varying contents of CaCO3 and DHQ. The films were produced via blown film extrusion using a laboratory extruder (SJ-28). Surface analysis was performed using scanning electron microscopy (SEM) and atomic force microscopy (AFM). Fourier-transform infrared (FTIR) spectroscopy was used to examine the film’s composition. The results showed that the introduction of more than 40.0 wt.% of CaCO3 into the polymer base affected the strength properties. The conducted studies of the physical and mechanical properties of LDPE film samples filled with CaCO3 showed significant changes in the samples containing more than 50.0 wt.% of the filler, with an increase in strength of more than 40.0%. The relative elongation at break after 50.0 wt.% decreased by more than 75.0%. These results indicate that to achieve the best strength properties for packaging materials, it is recommended to fill them to a maximum of 40.0 wt.%. The introduction of the antioxidant DHQ had almost no effect on the strength of the modified films. SEM analysis of films with high CaCO3 content and DHQ revealed visible antioxidant particles on the film surface, suggesting enhanced antioxidant potential at the interface between the film and dairy products. AFM analysis confirmed that a CaCO3 40.0 wt.% content altered the surface roughness and heterogeneity of the films. FTIR spectroscopy revealed that the incorporation of CaCO3 influenced the overall spectral profile of polyethylene, resulting in decreased peak intensities depending on the concentration of the filler. Based on these results, the modified polyethylene-based film with CaCO3 and DHQ shows potential for use as food packaging with antioxidant properties.

Schlagwörter

Stichwörter der Autor:innen

ATR-FTIR spectroscopyatomic force microscopy (AFM)calcium carbonatedihydroquercetinmicroplasticsmodificationscanning electron microscopy (SEM)tensile strength

Autor:innen und Institutionen

  • All-Russian Dairy Research Institute (VNIMI), 115093 Moscow, Russia.

Förderung

  • Ministry of Education and Science of the Russian Federation

Zitieren

APA

Myalenko, D., Fedotova, O., Agarkov, A., Sirotin, S., & Poletaeva, P. (2025). Tensile and Structural Properties of Antioxidant- and CaCO3-Modified Polyethylene Films. Polymers, 17(16), 2182. https://doi.org/10.3390/polym17162182

Vancouver

Myalenko D, Fedotova O, Agarkov A, Sirotin S, Poletaeva P. Tensile and Structural Properties of Antioxidant- and CaCO3-Modified Polyethylene Films. Polymers. 2025;17(16):2182. doi:10.3390/polym17162182

BibTeX
@article{Myalenko2025,
  author = {Myalenko, Dmitry and Fedotova, Olga and Agarkov, Aleksandr and Sirotin, Sergey and Poletaeva, Polina},
  title = {Tensile and Structural Properties of Antioxidant- and CaCO3-Modified Polyethylene Films},
  journal = {Polymers},
  year = {2025},
  volume = {17},
  number = {16},
  pages = {2182},
  doi = {10.3390/polym17162182}
}
Kostenlos starten →