Study on the Influence of Hygrothermal Aging on the Mechanical Properties of Carbon Fabric/Polyetheretherketone Composites
Polymers · 10.03.2025 · 17 (6) · 724
DOI: 10.3390/polym17060724 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 10.03.2025. Verfasst von Xiangyu Xu und 7 weiteren Autor:innen. Beteiligte Einrichtung: AVIC Manufacturing Technology Institute Composite Technology Center, Beijing 101300, China. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Key R&D Program of China, National Key R&D Program of China, Science Foundation of National Key Laboratory of Science and Technology on Advanced Composites in Special Environments.
Abstract (Originalsprache)
Owing to its superior mechanical properties and recyclability, the carbon fabric/polyetheretherketone (CFF/PEEK) composite has seen increasing application in engineering domains. However, studies examining the impact of hygrothermal aging on its performance remain relatively limited in the existing literature. To investigate its durability in hygrothermal environments, this study fabricated CFF/PEEK composites with a fiber volume fraction of 55 vol% and subjected them to equilibrium hygroscopic treatment at 70 °C. The hygroscopic behavior of polyetheretherketone (PEEK) resin and CFF/PEEK composites, along with their tensile and compressive properties under dry conditions at room temperature (RTD) and wet conditions at 70 °C (ETW), were systematically evaluated. The results indicated that both PEEK resin and CFF/PEEK composites exhibited Fickian diffusion behavior during the initial stages of aging but diverged in later stages. The equilibrium moisture absorption rates were approximately 0.32% for PEEK resin and 0.19% for CFF/PEEK composites. After aging at 70 °C, the strength of both materials decreased significantly, while the modulus showed only minor changes. Under ETW conditions, the tensile strength retention rate of PEEK resin was 74.92%, and the compressive strength retention rate was 81.85%. For the CFF/PEEK composites, the tensile strength retention rate was approximately 85%, and the compressive strength retention rate was about 95%. The typical failure modes of CFF/PEEK composites did not exhibit notable differences between tensile and compressive specimens after hygrothermal aging. Resin debonding was observed in the moisture-absorbed composite specimens, while no microcracks or delamination were detected. The degradation of mechanical properties is predominantly attributed to the deterioration of the resin matrix and interface characteristics, which are caused by water molecule intrusion and the adverse effects of wet strain mismatch between the resin and fibers.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- AVIC Manufacturing Technology Institute Composite Technology Center, Beijing 101300, China.
- School of Aerospace Engineering, Beijing Institute of Technology, Beijing 100081, China.
ORCID-Profile: Xiangyu Xu
Förderung
- National Key R&D Program of China
- National Key R&D Program of China
- Science Foundation of National Key Laboratory of Science and Technology on Advanced Composites in Special Environments
- Key Laboratory Foundation General program
Zitieren
APA
Xu, X., Zhang, B., Shi, F., Liu, K., Peng, G., Gao, L., Gao, J., & Du, Y. (2025). Study on the Influence of Hygrothermal Aging on the Mechanical Properties of Carbon Fabric/Polyetheretherketone Composites. Polymers, 17(6), 724. https://doi.org/10.3390/polym17060724
Vancouver
Xu X, Zhang B, Shi F, Liu K, Peng G, Gao L, et al. Study on the Influence of Hygrothermal Aging on the Mechanical Properties of Carbon Fabric/Polyetheretherketone Composites. Polymers. 2025;17(6):724. doi:10.3390/polym17060724
BibTeX
@article{Xu2025,
author = {Xu, Xiangyu and Zhang, Baoyan and Shi, Fenghui and Liu, Kai and Peng, Gongqiu and Gao, Liang and Gao, Junpeng and Du, Yu},
title = {Study on the Influence of Hygrothermal Aging on the Mechanical Properties of Carbon Fabric/Polyetheretherketone Composites},
journal = {Polymers},
year = {2025},
volume = {17},
number = {6},
pages = {724},
doi = {10.3390/polym17060724}
}
EUVIMED