Using Thin Ultra-High-Molecular-Weight Polyethylene Coatings to Reduce Friction in Frost-Resistant Rubbers
Polymers · 11.10.2024 · 16 (20) · 2870
DOI: 10.3390/polym16202870 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 11.10.2024. Verfasst von Elena Torskaya und 5 weiteren Autor:innen. Beteiligte Einrichtung: Ishlinsky Institute for Problems in Mechanics RAS, 119526 Moscow, Russia. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Russian Science Foundation.
Abstract (Originalsprache)
Frost-resistant rubbers retain their highly elastic properties over a wide temperature range. They are used in various friction units (e.g., seals), but their high friction coefficient and low wear resistance lead to the need for frequent replacement. In this paper, we propose applying thin (several hundred microns) UHMWPE coatings to formed rubber rings. The application technology depends on the required coating thickness. Friction tests of the coatings and pure UHMWPE were performed using the ball-on-disk (unidirectional sliding) scheme for various loads and velocities. In the experiments, the friction coefficients and temperatures near the contact area were determined. Friction tracks were studied using microscopy methods. The sliding contact of the ball and the two-layer material was modeled to obtain the dependences of the deformation component of friction on the sliding velocity for coatings of different thicknesses. UHMWPE is sensitive to frictional heating, so the thermal problem of determining the temperature in the contact area was also solved. It is shown that the minimum friction coefficient occurs for coatings with a thickness of 600 μm. At the same time, in the case of the 300 μm coating, the surface of the friction track is practically no different from the initial one. Thus, the studied combination of polymers provides antifrictional properties and wear resistance to the surface layer while maintaining the damping properties of rubber.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Ishlinsky Institute for Problems in Mechanics RAS, 119526 Moscow, Russia.
- Department of Chemistry, North-Eastern Federal University, 677000 Yakutsk, Russia.
Förderung
- Russian Science Foundation
Zitieren
APA
Torskaya, E., Shkalei, I., Stepanov, F., Makhovskaya, Y., Dyakonov, A., & Petrova, N. (2024). Using Thin Ultra-High-Molecular-Weight Polyethylene Coatings to Reduce Friction in Frost-Resistant Rubbers. Polymers, 16(20), 2870. https://doi.org/10.3390/polym16202870
Vancouver
Torskaya E, Shkalei I, Stepanov F, Makhovskaya Y, Dyakonov A, Petrova N. Using Thin Ultra-High-Molecular-Weight Polyethylene Coatings to Reduce Friction in Frost-Resistant Rubbers. Polymers. 2024;16(20):2870. doi:10.3390/polym16202870
BibTeX
@article{Torskaya2024,
author = {Torskaya, Elena and Shkalei, Ivan and Stepanov, Fedor and Makhovskaya, Yulia and Dyakonov, Afanasy and Petrova, Natalia},
title = {Using Thin Ultra-High-Molecular-Weight Polyethylene Coatings to Reduce Friction in Frost-Resistant Rubbers},
journal = {Polymers},
year = {2024},
volume = {16},
number = {20},
pages = {2870},
doi = {10.3390/polym16202870}
}
EUVIMED