Performance of Oriented Strand Board Made of Heat-Treated Bamboo (Dendrocalamus asper (Schult.) Backer) Strands
Polymers · 14.06.2024 · 16 (12) · 1692
DOI: 10.3390/polym16121692 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 14.06.2024. Verfasst von Sena Maulana und 14 weiteren Autor:innen. Beteiligte Einrichtung: Department of Forestry Engineering, Institut Teknologi Sumatera (ITERA), South Lampung, Lampung 35365, Indonesia. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 49 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Guru Besar under 45 ITERA Research Grant from the Institut Teknologi Sumatera, the Republic of Indonesia, Guru Besar under 45 ITERA Research Grant.
Abstract (Originalsprache)
This study aimed to analyze the effect of pre-heat treatment on bamboo strand properties and its impact on the properties of the resulting bamboo-oriented strand board (BOSB). Giant bamboo (Dendrocalamus asper (Schult.) Backer) with a density of 0.53 g cm−3 was converted into bamboo strands. These strands were pre-heat-treated at 140 and 160 °C for a duration of 1, 2, and 3 h. Changes in the chemical composition of the strand due to subsequent treatment were assessed. Fourier-transform infrared spectroscopy (FTIR) and X-Ray diffraction analysis (XRD) were used to determine the changes in the chemical composition of bamboo strands. The BOSB panels were produced with a target density of 0.7 g cm−3. The manufacturing of the BOSB was conducted in three layers with a ratio of 25:50:25, bonded with phenol-formaldehyde resin. The physical and mechanical properties of the laboratory-fabricated BOSB were tested in compliance with the criteria given in JIS A 5908 standards. Comparisons were made against OSB CSA 0437.0 Grade O-1 commercial standard. The pre-heat treatment led to chemical alterations within the material when set at 140 and 160 °C for 1 to 3 hours (h). FTIR spectral analysis demonstrated that longer exposure and higher temperatures resulted in fewer functional groups within the bamboo strands. The increased temperature and duration of pre-heat treatment enhanced the crystallinity index (CI). The dimensional stability and mechanical properties of the composites were improved significantly as hemicellulose and extractive content were reduced. This study demonstrated that the pre-heat treatment of bamboo strands at a temperature of 160 °C for a duration of 1 h was an adequate approach for heat modification and fabrication of BOSB panels with acceptable properties according to OSB CSA 0437.0 Grade O-1 commercial standard.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Forestry Engineering, Institut Teknologi Sumatera (ITERA), South Lampung, Lampung 35365, Indonesia.
- Research Center for Biomass and Bioproducts, National Research and Innovation Agency, Cibinong 16911, Indonesia.
- Faculty of Forest Industry, University of Forestry, 1797 Sofia, Bulgaria.
- Department of Wood Industry, Faculty of Applied Sciences, Universiti Teknologi MARA, Cawangan Pahang Kampus Jengka, Bandar Tun Razak 26400, Malaysia.
- Department of Material Engineering, Institut Teknologi Sumatera (ITERA), South Lampung, Lampung 35365, Indonesia.
- Center for Green and Sustainable Materials, Institut Teknologi Sumatera (ITERA), South Lampung, Lampung 35365, Indonesia.
ORCID-Profile: Sena Maulana, Petar Antov, Muhammad Iqbal Maulana, Sarah Augustina, Seng Hua Lee, Aditya Rianjanu, Lubos Kristak, Apri Heri Iswanto, Muhammad Adly Rahandi Lubis
Förderung
- Guru Besar under 45 ITERA Research Grant from the Institut Teknologi Sumatera, the Republic of Indonesia
- Guru Besar under 45 ITERA Research Grant
Zitieren
APA
Maulana, S., Suwanda, A. A., Murda, R. A., Antov, P., Komariah, R. N., Maulana, M. I., Augustina, S., Lee, S. H., Mahardika, M., Rianjanu, A., Taher, T., Kristak, L., Bindar, Y., Iswanto, A. H., & Lubis, M. A. R. (2024). Performance of Oriented Strand Board Made of Heat-Treated Bamboo (Dendrocalamus asper (Schult.) Backer) Strands. Polymers, 16(12), 1692. https://doi.org/10.3390/polym16121692
Vancouver
Maulana S, Suwanda AA, Murda RA, Antov P, Komariah RN, Maulana MI, et al. Performance of Oriented Strand Board Made of Heat-Treated Bamboo (Dendrocalamus asper (Schult.) Backer) Strands. Polymers. 2024;16(12):1692. doi:10.3390/polym16121692
BibTeX
@article{Maulana2024,
author = {Maulana, Sena and Suwanda, Astri Aulia and Murda, Rio Ardiansyah and Antov, Petar and Komariah, Rahma Nur and Maulana, Muhammad Iqbal and Augustina, Sarah and Lee, Seng Hua and Mahardika, Melbi and Rianjanu, Aditya and Taher, Tarmizi and Kristak, Lubos and Bindar, Yazid and Iswanto, Apri Heri and Lubis, Muhammad Adly Rahandi},
title = {Performance of Oriented Strand Board Made of Heat-Treated Bamboo (Dendrocalamus asper (Schult.) Backer) Strands},
journal = {Polymers},
year = {2024},
volume = {16},
number = {12},
pages = {1692},
doi = {10.3390/polym16121692}
}
EUVIMED