Influence of Three-Dimensional Printing Parameters on Compressive Properties and Surface Smoothness of Polylactic Acid Specimens
Polymers · 19.09.2023 · 15 (18) · 3827
DOI: 10.3390/polym15183827 ↗Kurz gefasst
Fachartikel in der Zeitschrift Polymers, online erschienen am 19.09.2023. Verfasst von Hamed Bakhtiari und 2 weiteren Autor:innen. Beteiligte Einrichtung: School of Engineering, Edith Cowan University, Joondalup, WA 6027, Australia. Die Arbeit wurde bisher 57-mal zitiert (Crossref) und nennt 71 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
While the mechanical performance of fused filament fabrication (FFF) parts has been extensively studied in terms of the tensile and bending strength, limited research accounts for their compressive performance. This study investigates the effect of four process parameters (layer height, extrusion width, nozzle temperature, and printing speed) on the compressive properties and surface smoothness of FFF parts made of Polylactic Acid (PLA). The orthogonal Taguchi method was employed for designing the experiments. The surface roughness and compressive properties of the specimens were then measured and optimized using the analysis of variance (ANOVA). A microscopic analysis was also performed to identify the failure mechanism under static compression. The results indicated that the layer height had the most significant influence on all studied properties, followed by the print speed in the case of compressive modulus, hysteresis loss, and residual strain; extrusion width in the case of compressive strength and specific strength; and nozzle temperature in the case of toughness and failure strain. The optimal design for both high compressive properties and surface smoothness were determined as a 0.05 mm layer height, 0.65 mm extrusion width, 205 °C nozzle temperature, and 70 mm/s print speed. The main failure mechanism observed by SEM analysis was delamination between layers, occurring at highly stressed points near the stitch line of the PLA prints.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Engineering, Edith Cowan University, Joondalup, WA 6027, Australia.
- Department of Mechanical and Product Design Engineering, School of Engineering, Swinburne University of Technology, Hawthorn, VIC 3122, Australia.
ORCID-Profile: Hamed Bakhtiari, Majid Tolouei-Rad
Zitieren
APA
Bakhtiari, H., Nikzad, M., & Tolouei-Rad, M. (2023). Influence of Three-Dimensional Printing Parameters on Compressive Properties and Surface Smoothness of Polylactic Acid Specimens. Polymers, 15(18), 3827. https://doi.org/10.3390/polym15183827
Vancouver
Bakhtiari H, Nikzad M, Tolouei-Rad M. Influence of Three-Dimensional Printing Parameters on Compressive Properties and Surface Smoothness of Polylactic Acid Specimens. Polymers. 2023;15(18):3827. doi:10.3390/polym15183827
BibTeX
@article{Bakhtiari2023,
author = {Bakhtiari, Hamed and Nikzad, Mostafa and Tolouei-Rad, Majid},
title = {Influence of Three-Dimensional Printing Parameters on Compressive Properties and Surface Smoothness of Polylactic Acid Specimens},
journal = {Polymers},
year = {2023},
volume = {15},
number = {18},
pages = {3827},
doi = {10.3390/polym15183827}
}
EUVIMED