EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Fe Content on the Microstructure Evolution and Deformation Mechanism of Warm-Rolled Cu-Fe Alloy

Baosen Lin, Su Huang, Shuai Tang iD, Dongxiao Wang, Jianping Li iD

Nanomaterials · 08.07.2026 · 16 (14) · 839

DOI: 10.3390/nano16140839 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 08.07.2026. Verfasst von Baosen Lin und 4 weiteren Autor:innen. Beteiligte Einrichtung: State Key Laboratory of Digital Steel, Northeastern University, Shenyang 110819, China. Die Arbeit nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Cu–Fe alloys combine the high electrical conductivity of Cu with the strengthening and magnetic contributions of Fe, making them promising high-strength, electrically conductive functional materials. However, for high-Fe Cu–Fe alloys with Fe contents exceeding 10 wt.%, the microstructural response, texture evolution, and two-phase deformation partitioning during warm rolling remain insufficiently understood. In this study, Cu–10Fe, Cu–15Fe, and Cu–20Fe alloys were investigated to clarify the effect of Fe content on microstructure evolution, texture characteristics, deformation behavior, and property balance after single-pass warm rolling at 500 °C with a 50% reduction. The results show that, as the Fe content increased from 10% to 20%, the Fe-rich phase became progressively denser after warm rolling and gradually transformed from discrete spherical/spindle-like particles into fibrous structures distributed along the rolling direction, while the average grain size of the alloy decreased. EBSD analysis indicates that increasing Fe content weakened the preferred orientation of the Cu matrix. The maximum texture intensity of the Cu matrix decreased from 5.08 to 4.21, and texture showed a weakening trend. The mechanical properties show that, with increasing Fe content, the ultimate tensile strength increased from 434 MPa to 514 MPa, whereas the elongation decreased from 10.7% to 5.1%. This indicates that the increased amount of Fe-rich phase enhanced strength but reduced plasticity; nevertheless, dynamic recovery and local recrystallization induced by warm rolling helped maintain a certain degree of ductility. The electrical conductivity decreased from 19.43% IACS to 16.71% IACS with increasing Fe content, corresponding to a decrease of only approximately 2.7% IACS, suggesting that warm rolling partially mitigated the negative effect of increasing Fe content on electrical conductivity. Based on the combined microstructural, texture, and KAM/GND analyses, the deformation behavior of the alloys with increasing Fe content exhibited a transition from heterogeneous deformation dominated by the Cu matrix/interface to cooperative deformation involving the Fe-rich phase.

Schlagwörter

Stichwörter der Autor:innen

Cu-Fe alloyFe contentdeformation mechanismmicrostructurewarm rolling

Autor:innen und Institutionen

  • State Key Laboratory of Digital Steel, Northeastern University, Shenyang 110819, China.
  • School of Mechanical Engineering, Xijing University, Xi'an 710123, China.

ORCID-Profile: Shuai Tang, Jianping Li

Förderung

  • National Natural Science Foundation of China

Zitieren

APA

Lin, B., Huang, S., Tang, S., Wang, D., & Li, J. (2026). Effect of Fe Content on the Microstructure Evolution and Deformation Mechanism of Warm-Rolled Cu-Fe Alloy. Nanomaterials, 16(14), 839. https://doi.org/10.3390/nano16140839

Vancouver

Lin B, Huang S, Tang S, Wang D, Li J. Effect of Fe Content on the Microstructure Evolution and Deformation Mechanism of Warm-Rolled Cu-Fe Alloy. Nanomaterials. 2026;16(14):839. doi:10.3390/nano16140839

BibTeX
@article{Lin2026,
  author = {Lin, Baosen and Huang, Su and Tang, Shuai and Wang, Dongxiao and Li, Jianping},
  title = {Effect of Fe Content on the Microstructure Evolution and Deformation Mechanism of Warm-Rolled Cu-Fe Alloy},
  journal = {Nanomaterials},
  year = {2026},
  volume = {16},
  number = {14},
  pages = {839},
  doi = {10.3390/nano16140839}
}
Kostenlos starten →