Tailoring the Microstructure and Properties of HiPIMS-Deposited DLC-Cr Nanocomposite Films via Chromium Doping
Nanomaterials · 22.01.2026 · 16 (2) · 150
DOI: 10.3390/nano16020150 ↗Kurz gefasst
Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 22.01.2026. Verfasst von Jicheng Ding und 7 weiteren Autor:innen. Beteiligte Einrichtung: China International Science and Technology Cooperation Base on Intelligent Equipment Manufacturing in Special Service Environment, Anhui University o…. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: China International Science and Technology Cooperation Base on Intelligent Equipment Manufacturing in Special Service Environment, Anhui Postdoctoral Scientific Research Program Foundation.
Abstract (Originalsprache)
Chromium-doped diamond-like carbon (DLC-Cr) nanocomposite films were successfully deposited using a high-power impulse magnetron sputtering (HiPIMS) system. The Cr content in the films was controlled by adjusting the Cr target powers. The influence of Cr content on the microstructure, mechanical properties, tribological performance, and wettability of the films was systematically investigated. The results show that the Cr content and deposition rate of the films increased with increases in the target power. The surface topography of the films evolved from smooth to rough as the Cr target increased from 10 W to 70 W. At low Cr doping rates, the film mainly exhibited an amorphous structure, whereas the nanocomposite structure was formed at proper Cr doping rates. Raman and XPS analyses revealed that Cr incorporation altered the ID/IG ratio and promoted the formation of Cr-C bonds, leading to a more graphitic and nanocomposite-like structure. The nanoindentation results show that an optimal Cr content enhances both hardness and elastic modulus, while higher Cr concentrations lead to a decline in mechanical strength due to more graphitization and decreasing stress. Tribological tests exhibited a significant reduction in the friction coefficient (0.21) and wear rate (0.63 × 10−14 m3/N·m) at a moderate Cr level. Additionally, the surface wettability evolved toward enhanced hydrophilicity with increasing Cr power, as evidenced by reduced water contact angles and increased surface energy. These findings demonstrate that controlled Cr incorporation effectively tailors the structure, stress state, and surface chemistry of DLC films, offering a tunable pathway to achieving optimal mechanical performance and tribological stability for advanced engineering applications.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- China International Science and Technology Cooperation Base on Intelligent Equipment Manufacturing in Special Service Environment, Anhui University of Technology, Maanshan 243002, China.
- Key Laboratory of Green Fabrication and Surface Technology of Advanced Metal Materials, Ministry of Education, Anhui University of Technology, Maanshan 243002, China.
- School of Materials Science and Engineering, Anhui University of Technology, Maanshan 243002, China.
- Guangdong Provincial Key Laboratory of Electronic Functional Materials and Devices, Huizhou University, Huizhou 516007, China.
ORCID-Profile: Haijuan Mei
Förderung
- China International Science and Technology Cooperation Base on Intelligent Equipment Manufacturing in Special Service Environment
- Anhui Postdoctoral Scientific Research Program Foundation
Zitieren
APA
Ding, J., Zhuang, W., Wang, Q., Wang, Q., Mei, H., Zhao, D., Liu, X., & Zheng, J. (2026). Tailoring the Microstructure and Properties of HiPIMS-Deposited DLC-Cr Nanocomposite Films via Chromium Doping. Nanomaterials, 16(2), 150. https://doi.org/10.3390/nano16020150
Vancouver
Ding J, Zhuang W, Wang Q, Wang Q, Mei H, Zhao D, et al. Tailoring the Microstructure and Properties of HiPIMS-Deposited DLC-Cr Nanocomposite Films via Chromium Doping. Nanomaterials. 2026;16(2):150. doi:10.3390/nano16020150
BibTeX
@article{Ding2026,
author = {Ding, Jicheng and Zhuang, Wenjian and Wang, Qingye and Wang, Qi and Mei, Haijuan and Zhao, Dongcai and Liu, Xingguang and Zheng, Jun},
title = {Tailoring the Microstructure and Properties of HiPIMS-Deposited DLC-Cr Nanocomposite Films via Chromium Doping},
journal = {Nanomaterials},
year = {2026},
volume = {16},
number = {2},
pages = {150},
doi = {10.3390/nano16020150}
}
EUVIMED