EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Engineering the Morphology and Properties of MoS2 Films Through Gaseous Precursor-Induced Vacancy Defect Control

James Abraham, Nigel D Shepherd iD, Chris Littler iD, A J Syllaios, Usha Philipose iD

Nanomaterials · 14.11.2025 · 15 (22) · 1723

DOI: 10.3390/nano15221723 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 14.11.2025. Verfasst von James Abraham und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Physics, University of North Texas, 1155 Union Cir., Denton, TX 76203, USA. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Office of Naval Research.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The morphology, structure, and composition of CVD-grown molybdenum disulfide (MoS2) films were investigated under varying precursor vapor pressures. Increasing sulfur vapor pressure transformed the film morphology from well-defined triangular domains to structures dominated by sulfur-terminated zigzag edges. These morphological changes were accompanied by notable variations in both structural and electrical properties. Non-uniform precursor vapor distribution promoted the formation of intrinsic point defects. To elucidate this behavior, a thermodynamic model was developed to link growth parameters to native defect formation. The analysis considered molybdenum and sulfur vacancies in both neutral and charged states, with equilibrium concentrations determined from the corresponding defect formation reactions. Sulfur vapor pressure emerged as the dominant factor controlling defect concentrations. The model validated experimental observations, with films grown under optimum and sulfur-rich conditions, yielding a carrier concentration of 9.6×1011 cm−2 and 7.5×1011 cm−2, respectively. The major difference in the field-effect transistor (FET) performance of devices fabricated under these two conditions was the degradation of the field-effect mobility and the current switching ratio. The degradation observed is attributed to increased carrier scattering at charged vacancy defect sites.

Schlagwörter

Stichwörter der Autor:innen

CVD growthMoS2charge transportvacancy defects

Autor:innen und Institutionen

  • Department of Physics, University of North Texas, 1155 Union Cir., Denton, TX 76203, USA.
  • Department of Material Science and Engineering, University of North Texas Discovery Park, 3940 N Elm St., Denton, TX 76207, USA.
  • Center for Microelectronics in Extreme Environments, University of North Texas Discovery Park, 3940 N Elm St., Denton, TX 76207, USA.

ORCID-Profile: Nigel D Shepherd, Chris Littler, Usha Philipose

Förderung

  • Office of Naval Research

Zitieren

APA

Abraham, J., Shepherd, N. D., Littler, C., Syllaios, A. J., & Philipose, U. (2025). Engineering the Morphology and Properties of MoS2 Films Through Gaseous Precursor-Induced Vacancy Defect Control. Nanomaterials, 15(22), 1723. https://doi.org/10.3390/nano15221723

Vancouver

Abraham J, Shepherd ND, Littler C, Syllaios AJ, Philipose U. Engineering the Morphology and Properties of MoS2 Films Through Gaseous Precursor-Induced Vacancy Defect Control. Nanomaterials. 2025;15(22):1723. doi:10.3390/nano15221723

BibTeX
@article{Abraham2025,
  author = {Abraham, James and Shepherd, Nigel D and Littler, Chris and Syllaios, A J and Philipose, Usha},
  title = {Engineering the Morphology and Properties of MoS2 Films Through Gaseous Precursor-Induced Vacancy Defect Control},
  journal = {Nanomaterials},
  year = {2025},
  volume = {15},
  number = {22},
  pages = {1723},
  doi = {10.3390/nano15221723}
}
Kostenlos starten →