EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Pool Boiling Heat Transfer Characteristics of SiO2 and BN Nanoparticles Dispersed Mono and Hybrid Nanofluids

Wagd Ajeeb, S M Sohel Murshed iD

Nanomaterials · 23.09.2023 · 13 (19) · 2625

DOI: 10.3390/nano13192625 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomaterials, online erschienen am 23.09.2023. Verfasst von Wagd Ajeeb und 1 weiteren Autor:innen. Beteiligte Einrichtung: IDMEC, Instituto Superior Técnico, University of Lisbon, 1049-001 Lisbon, Portugal. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fundação para a Ciência e Tecnologia, Fundação para a Ciência e Tecnologia (FCT), Portugal.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study reports an experimental investigation of pool boiling (PB) heat transfer performance of hybrid (two types of particles) and mono (single-particle) nanofluids consisting of Boron nitride (BN) and Silicon dioxide (SiO2) nanoparticles (NPs). While hybrid nanofluids (HNFs) were prepared in a total particle concentration of 0.05 vol.% with four different percentages of these two types of NPs (are 0.01/0.04, 0.02/ 0.03, 0.03/0.02, and 0.04/0.01 (BN vol.%/SiO2 vol.%)), two mono nanofluids (MNFs) of BN and SiO2 nanoparticles were prepared at the same total concentration of 0.05 vol.% for each NP type. Both nanofluids (NFs) were prepared in the base fluid (BF), which is the mixture of 15 vol.% of ethylene glycol (EG) and 85 vol.% of distilled water (DW). Then, the boiling heat transfer performance of these MNFs and HNFs was assessed by experimentation in a pool boiling test rig. The obtained results demonstrated good improvements in critical heat flux (CHF) and burnout heat flux (BHF) of both types of NFs. The CHF increased by up to 80% for BN-based MNF and up to 69% for HNF at 0.04 vol.% BN, which is the maximum percentage of BN into HNF, while the lowest improvement in CHF was 48% for the SiO2-based MNF compared to the BF. Similarly, the BHF was found to increase with the increasing in the loading of BN nanoparticles and a maximum enhancement of BHF of 103% for BN-based MNF was observed. These HNFs and MNFs exhibited significantly improved pool boiling heat transfer performance compared to this BF, and it became lower by increasing the percentage of SiO2 NPs in the HNFs.

Schlagwörter

Stichwörter der Autor:innen

boron nitrideburnout heat fluxcritical heat fluxhybrid nanofluidspool boilingsilica

Autor:innen und Institutionen

  • IDMEC, Instituto Superior Técnico, University of Lisbon, 1049-001 Lisbon, Portugal.

ORCID-Profile: S M Sohel Murshed

Förderung

  • Fundação para a Ciência e Tecnologia
  • Fundação para a Ciência e Tecnologia (FCT), Portugal

Zitieren

APA

Ajeeb, W., & Murshed, S. M. S. (2023). Pool Boiling Heat Transfer Characteristics of SiO2 and BN Nanoparticles Dispersed Mono and Hybrid Nanofluids. Nanomaterials, 13(19), 2625. https://doi.org/10.3390/nano13192625

Vancouver

Ajeeb W, Murshed SMS. Pool Boiling Heat Transfer Characteristics of SiO2 and BN Nanoparticles Dispersed Mono and Hybrid Nanofluids. Nanomaterials. 2023;13(19):2625. doi:10.3390/nano13192625

BibTeX
@article{Ajeeb2023,
  author = {Ajeeb, Wagd and Murshed, S M Sohel},
  title = {Pool Boiling Heat Transfer Characteristics of SiO2 and BN Nanoparticles Dispersed Mono and Hybrid Nanofluids},
  journal = {Nanomaterials},
  year = {2023},
  volume = {13},
  number = {19},
  pages = {2625},
  doi = {10.3390/nano13192625}
}
Kostenlos starten →