Surface Topography in Cutting-Speed-Direction Ultrasonic-Assisted Turning
Micromachines · 21.05.2024 · 15 (6) · 668
DOI: 10.3390/mi15060668 ↗Kurz gefasst
Fachartikel in der Zeitschrift Micromachines, online erschienen am 21.05.2024. Verfasst von Thanh-Trung Nguyen und 2 weiteren Autor:innen. Beteiligte Einrichtung: Precision Engineering and Smart Measurements Lab, School of Mechanical Engineering, Hanoi University of Science and Technology, Hanoi 100000, Vietnam. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Hanoi University of Science and Technology.
Abstract (Originalsprache)
Ultrasonic vibration has been employed to assist in turning, introducing intermittent machining to reduce average cutting force, minimize tool wear, and enhance machining efficiency, thereby improving surface roughness. However, achieving intermittent cutting necessitates specific conditions, with a cutting speed or feed rate falling below the critical speed associated with the ultrasonic vibration parameters. This study presents a theoretical model for surface formation in cutting-speed-direction ultrasonic-assisted turning (CUAT), covering both continuous and intermittent machining regimes. Experimental validation was conducted on C45 carbon steel and 201 stainless steel to demonstrate the applicability of the theoretical model across different materials. Digital microscope analysis revealed 3D topography consistency with the theoretical formula. Surface roughness evaluations were performed for both CUAT and CT (conventional turning) methods. The results indicated a significant reduction in roughness Ra for C45 steel samples machined with CUAT, up to 80% compared to CT at a cutting speed of 20 m/min, while only exhibiting slight fluctuations when turning 201 stainless steel. Detailed analysis and explanation of these phenomena are presented herein.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Precision Engineering and Smart Measurements Lab, School of Mechanical Engineering, Hanoi University of Science and Technology, Hanoi 100000, Vietnam.
ORCID-Profile: Thanh-Trung Nguyen, Toan-Thang Vu, Thanh-Dong Nguyen
Förderung
- Hanoi University of Science and Technology
Zitieren
APA
Nguyen, T. T., Vu, T. T., & Nguyen, T. D. (2024). Surface Topography in Cutting-Speed-Direction Ultrasonic-Assisted Turning. Micromachines, 15(6), 668. https://doi.org/10.3390/mi15060668
Vancouver
Nguyen TT, Vu TT, Nguyen TD. Surface Topography in Cutting-Speed-Direction Ultrasonic-Assisted Turning. Micromachines. 2024;15(6):668. doi:10.3390/mi15060668
BibTeX
@article{Nguyen2024,
author = {Nguyen, Thanh-Trung and Vu, Toan-Thang and Nguyen, Thanh-Dong},
title = {Surface Topography in Cutting-Speed-Direction Ultrasonic-Assisted Turning},
journal = {Micromachines},
year = {2024},
volume = {15},
number = {6},
pages = {668},
doi = {10.3390/mi15060668}
}
EUVIMED