EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Influence of Support Roughness on Shape Distortion of Binder-Jetted Parts During Sintering—Experimental and Modelling Analysis

Amani Elabbassi, Marco Zago, Thomas Grippi, Ilaria Cristofolini

Metals · 13.11.2026 · 16 (11) · 1250

DOI: 10.3390/met16111250 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 13.11.2026. Verfasst von Amani Elabbassi und 3 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In recent years, metal binder jetting (MBJ) has seen increasing adoption in diverse manufacturing sectors due to its scalability, design flexibility, and high cost-efficiency. Sintering the green part at high temperature is an essential step to obtain a nominal product; nonetheless, it may detrimentally affect dimensional and geometrical accuracy, as parts with complex geometries undergo shape distortion because of gravity and/or friction at the contact area with the sintering trays. This study aimed to investigate the friction-induced deformation of sintering stainless-steel 316L thin-walled cubes on alumina supports with different surface finishing; arithmetic average roughness (Ra) and Maximum Height of the Profile (Rz) ranged from 0.2 to 12 μm and 3 to 60 μm, respectively. The deviation in the sintered cubes, measured using a Coordinate Measuring Machine (CMM), did not show a clear pattern as a function of surface finishing. Finite Element Modelling (FEM) confirmed that shape distortion during sintering marginally increases with an increase in the friction coefficient. Assuming a heterogeneous initial density distribution, the simulation results showed good agreement in predicting the concave deformation patterns observed in many samples (~0.45 mm, less than 5% error along the y-direction). This work proposes novel insight into the influence of tray roughness and the combined effect of friction and density distribution on shape distortion during sintering.

Zitieren

APA

Elabbassi, A., Zago, M., Grippi, T., & Cristofolini, I. (2026). The Influence of Support Roughness on Shape Distortion of Binder-Jetted Parts During Sintering—Experimental and Modelling Analysis. Metals, 16(11), 1250. https://doi.org/10.3390/met16111250

Vancouver

Elabbassi A, Zago M, Grippi T, Cristofolini I. The Influence of Support Roughness on Shape Distortion of Binder-Jetted Parts During Sintering—Experimental and Modelling Analysis. Metals. 2026;16(11):1250. doi:10.3390/met16111250

BibTeX
@article{Elabbassi2026,
  author = {Elabbassi, Amani and Zago, Marco and Grippi, Thomas and Cristofolini, Ilaria},
  title = {The Influence of Support Roughness on Shape Distortion of Binder-Jetted Parts During Sintering—Experimental and Modelling Analysis},
  journal = {Metals},
  year = {2026},
  volume = {16},
  number = {11},
  pages = {1250},
  doi = {10.3390/met16111250}
}
Kostenlos starten →