Asymmetric Residual Stress Distribution in Friction Stir Welded Magnesium Alloy: A Sequentially Coupled Thermo-Mechanical Analysis
Metals · 11.07.2026 · 16 (7) · 774
DOI: 10.3390/met16070774 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 11.07.2026. Verfasst von Huiting Wu und 3 weiteren Autor:innen. Die Arbeit nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, National Key Research and Development Program of China, Young S&T Talent Training Program of Guangdong Provincial Association for S&T, China.
Abstract (Originalsprache)
Friction stir welding (FSW) is an effective solid-state joining technique for magnesium alloys such as AZ31, owing to its ability to minimize conventional welding defects. Nevertheless, the process generates significant residual stresses that can impair the fatigue performance and dimensional stability of welded structures. In this study, a sequentially coupled thermo-mechanical finite element model was employed to characterize the residual stress distribution in FSW AZ31 Mg alloy. The calculated near-surface longitudinal residual stress was assessed against XRD measurements at five locations on the top surface, giving a root mean square error of about 10.34 MPa. The results revealed an M-shaped longitudinal residual stress profile with marked asymmetry between the advancing and retreating sides, associated with non-uniform heat input and the resulting asymmetric temperature history. Among the three stress components, the longitudinal residual stress was the largest, followed by the transverse component, while the normal stress was the smallest. The thermo-mechanically affected zone and the crown zone exhibited higher residual stresses compared to the heat-affected zone. In addition, the influences of welding speed and tool rotational speed on residual stress evolution were systematically evaluated. The longitudinal residual stress increased with welding speed up to 350 mm/min and subsequently decreased, while a peak value was observed at 1200 rpm. These numerical results provide useful guidance, within the studied parameter range, for welding-parameter selection and residual-stress control in magnesium alloy joints.
Förderung
- National Natural Science Foundation of China
- National Key Research and Development Program of China
- Young S&T Talent Training Program of Guangdong Provincial Association for S&T, China
- GDAS’ Project of Science and Technology Development
Zitieren
APA
Wu, H., Feng, S., Liu, Z., & Xin, R. (2026). Asymmetric Residual Stress Distribution in Friction Stir Welded Magnesium Alloy: A Sequentially Coupled Thermo-Mechanical Analysis. Metals, 16(7), 774. https://doi.org/10.3390/met16070774
Vancouver
Wu H, Feng S, Liu Z, Xin R. Asymmetric Residual Stress Distribution in Friction Stir Welded Magnesium Alloy: A Sequentially Coupled Thermo-Mechanical Analysis. Metals. 2026;16(7):774. doi:10.3390/met16070774
BibTeX
@article{Wu2026,
author = {Wu, Huiting and Feng, Sili and Liu, Zhe and Xin, Renlong},
title = {Asymmetric Residual Stress Distribution in Friction Stir Welded Magnesium Alloy: A Sequentially Coupled Thermo-Mechanical Analysis},
journal = {Metals},
year = {2026},
volume = {16},
number = {7},
pages = {774},
doi = {10.3390/met16070774}
}
EUVIMED