EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Lower Sheet Hole on Joint Strength in Pre-Holed Hot Clinching of Al-Si-Coated 22MnB5 Steel Sheets

Jarupong Charoensuk, Takuma Iwai, Taiga Hongo, Tomoyoshi Maeno, Surasak Suranuntchai

Metals · 12.05.2026 · 16 (5) · 524

DOI: 10.3390/met16050524 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 12.05.2026. Verfasst von Jarupong Charoensuk und 4 weiteren Autor:innen. Die Arbeit nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study introduced a pre-holed hot clinching process for hot stamping patchwork blanks, using the lower sheet pre-hole as a forming cavity to facilitate material flow and minimize deformation resistance. Evaluated through mechanical testing and finite element analysis (FEA), the process induced ausforming and maintained material homogeneity (~500 HV), and an optimal interfacial gap up to 10 mm effectively prevented localized soft-zone fractures. Results identified interfacial slip, driven by a critical differential surface expansion rate, as the primary mechanism for geometric anchoring and solid-state bonding. Experimental validation established optimal joining at a 60% penetration ratio and a 0.9 hole-to-punch diameter ratio. While prior studies on forge joining reported average maximum strengths limited to 1.2 kN due to the absence of a mechanical hook, the optimized pre-holed joints in this work achieved a superior tensile shear capacity of 11.5 kN. Furthermore, the cross-tension load reached 0.77 kN, representing a nearly tenfold increase compared to the 0.08 kN observed in the no-hole with offset condition. These results demonstrate that the pre-holed hot clinching method significantly enhances joint integrity while reducing the forming load from 70 kN without a pre-hole to 12 kN with a 10 mm pre-hole.

Zitieren

APA

Charoensuk, J., Iwai, T., Hongo, T., Maeno, T., & Suranuntchai, S. (2026). Effect of Lower Sheet Hole on Joint Strength in Pre-Holed Hot Clinching of Al-Si-Coated 22MnB5 Steel Sheets. Metals, 16(5), 524. https://doi.org/10.3390/met16050524

Vancouver

Charoensuk J, Iwai T, Hongo T, Maeno T, Suranuntchai S. Effect of Lower Sheet Hole on Joint Strength in Pre-Holed Hot Clinching of Al-Si-Coated 22MnB5 Steel Sheets. Metals. 2026;16(5):524. doi:10.3390/met16050524

BibTeX
@article{Charoensuk2026,
  author = {Charoensuk, Jarupong and Iwai, Takuma and Hongo, Taiga and Maeno, Tomoyoshi and Suranuntchai, Surasak},
  title = {Effect of Lower Sheet Hole on Joint Strength in Pre-Holed Hot Clinching of Al-Si-Coated 22MnB5 Steel Sheets},
  journal = {Metals},
  year = {2026},
  volume = {16},
  number = {5},
  pages = {524},
  doi = {10.3390/met16050524}
}
Kostenlos starten →