EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Al Substitution of Si on the Microstructure, Retained Austenite Stability and Mechanical Properties of Low-Alloyed TRIP-Aided Steels

Jianeng Huang, Guangyao Le, Shanshan Ding, Chuanbin Zang, Hongxiang Chen, Pinqiang Dai, Zhengyou Tang

Metals · 29.03.2026 · 16 (4) · 379

DOI: 10.3390/met16040379 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 29.03.2026. Verfasst von Jianeng Huang und 6 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fujian Regional Development Project, Fujian Provincial Guided Project, Fujian Provincial STS Program.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this work, the effect of partial to complete Al substitution of Si on the microstructure, retained austenite (RA) stability, and mechanical properties of cold-rolled TRIP-aided steels was investigated. Four experimental TRIP-aided steels (Fe-0.2C-1.5Mn-1.5/1.0/0.5/0Si-0/0.5/1.0/1.5Al-0.025Nb, wt.%) were designed. The results indicate that replacing Si with Al significantly increases the volume fraction of soft polygonal ferrite (from 52% to 73%) and decreases that of bainite. Although the volume fraction of RA decreases (from 15.6% to 12.4%), its average carbon content and, consequently, its mechanical stability are enhanced, which suppresses the strain-induced martensitic transformation. In terms of mechanical properties, the substitution leads to a monotonic decrease in both yield strength (from 573 MPa to 536 MPa) and ultimate tensile strength (UTS) (from 839 MPa to 648 MPa), primarily due to reduced solid-solution strengthening, coarsened ferrite grains, and a weakened TRIP effect. Conversely, the total elongation (TEL) increases from 28.3% to 32.4%, attributed to the higher fraction of ductile ferrite. Consequently, the product of tensile strength and total elongation (PSE) exhibits a slight decline. The 1.5Si-TRIP steel exhibited the most balanced mechanical properties, achieving the highest PSE of 23.7 GPa·%.

Förderung

  • Fujian Regional Development Project
  • Fujian Provincial Guided Project
  • Fujian Provincial STS Program
  • Natural Science Foundation of Fujian Province

Zitieren

APA

Huang, J., Le, G., Ding, S., Zang, C., Chen, H., Dai, P., & Tang, Z. (2026). Effect of Al Substitution of Si on the Microstructure, Retained Austenite Stability and Mechanical Properties of Low-Alloyed TRIP-Aided Steels. Metals, 16(4), 379. https://doi.org/10.3390/met16040379

Vancouver

Huang J, Le G, Ding S, Zang C, Chen H, Dai P, et al. Effect of Al Substitution of Si on the Microstructure, Retained Austenite Stability and Mechanical Properties of Low-Alloyed TRIP-Aided Steels. Metals. 2026;16(4):379. doi:10.3390/met16040379

BibTeX
@article{Huang2026,
  author = {Huang, Jianeng and Le, Guangyao and Ding, Shanshan and Zang, Chuanbin and Chen, Hongxiang and Dai, Pinqiang and Tang, Zhengyou},
  title = {Effect of Al Substitution of Si on the Microstructure, Retained Austenite Stability and Mechanical Properties of Low-Alloyed TRIP-Aided Steels},
  journal = {Metals},
  year = {2026},
  volume = {16},
  number = {4},
  pages = {379},
  doi = {10.3390/met16040379}
}
Kostenlos starten →