Finite Element Modeling and Experimental Verification of a New Aluminum Al-2%Cu-2%Mn Alloy Hot Cladding by Flat Rolling
Metals · 25.07.2024 · 14 (8) · 852
DOI: 10.3390/met14080852 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 25.07.2024. Verfasst von Alexander Koshmin und 5 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Russian Science Foundation, Moscow Polytechnic University within the framework of the grant named after Pyotr Kapitsa.
Abstract (Originalsprache)
The roll bonding of an experimental Al-2%Cu-2%Mn alloy with technically pure 1050A aluminum at true deformations of 0.26, 0.33 and 0.40 has been simulated using the QForm 10.3.0 FEM software. The flow stress of the Al-2%Cu-2%Mn alloy has been measured in temperature and strain rate ranges of 350–450 °C and 0.1–20 s−1, respectively. The simulation results suggest that the equivalent strain in the cladding layer is more intense than that in the base layer, reaching 1.0, 1.4 and 2.0 at strains of 0.26, 0.33 and 0.40, respectively. The latter fact favors a decrease in the difference between the flow stresses of the rolled sheet layer contact surfaces by an average of 25% at the highest strain. The experimental roll bonding has achieved good layer adhesion for all the test samples. The average peeling strength of the samples produced at strains of 0.26 and 0.33 proves to be 12.6 and 18.4 N/mm, respectively, and at a strain of 0.40, it has exceeded the flow stress of the 1050A alloy cladding layer. The change in the rolling force for different rolling routes has demonstrated the best fit with the experimental data.
Förderung
- Russian Science Foundation
- Moscow Polytechnic University within the framework of the grant named after Pyotr Kapitsa
Zitieren
APA
Koshmin, A., Zinoviev, A., Cherkasov, S., Ali, A. M. A., Tsydenov, K., & Churyumov, A. (2024). Finite Element Modeling and Experimental Verification of a New Aluminum Al-2%Cu-2%Mn Alloy Hot Cladding by Flat Rolling. Metals, 14(8), 852. https://doi.org/10.3390/met14080852
Vancouver
Koshmin A, Zinoviev A, Cherkasov S, Ali AMA, Tsydenov K, Churyumov A. Finite Element Modeling and Experimental Verification of a New Aluminum Al-2%Cu-2%Mn Alloy Hot Cladding by Flat Rolling. Metals. 2024;14(8):852. doi:10.3390/met14080852
BibTeX
@article{Koshmin2024,
author = {Koshmin, Alexander and Zinoviev, Alexander and Cherkasov, Stanislav and Ali, Abdullah Mahmoud Alhaj and Tsydenov, Kirill and Churyumov, Alexander},
title = {Finite Element Modeling and Experimental Verification of a New Aluminum Al-2%Cu-2%Mn Alloy Hot Cladding by Flat Rolling},
journal = {Metals},
year = {2024},
volume = {14},
number = {8},
pages = {852},
doi = {10.3390/met14080852}
}
EUVIMED