EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Different Aspects of Machinability in Turning of AISI 304 Stainless Steel: A Sustainable Approach with MQL Technology

Rüstem Binali, Havva Demirpolat, Mustafa Kuntoğlu, Emin Salur

Metals · 08.06.2023 · 13 (6) · 1088

DOI: 10.3390/met13061088 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metals, online erschienen am 08.06.2023. Verfasst von Rüstem Binali und 3 weiteren Autor:innen. Die Arbeit wurde bisher 64-mal zitiert (Crossref) und nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Machining of AISI 304 austenitic stainless steel is considered to be difficult due to its structural aspects and low thermal conductivity, which leads to increased temperatures during machining. To overcome the challenges of machining AISI 304 stainless steel, several cooling and lubricating techniques have been developed. The main objective of this experimental study is to evaluate the different turning conditions of AISI304 stainless steel under dry and minimum quantity lubrication (MQL) environment conditions. The machining experiments were conducted using a two-level full factorial design method and utilized a TiC-coated cutting tool. The tool-tip temperature, cutting force and surface roughness were analyzed regarding three cutting parameters namely, cutting speed, feed rate and cutting depth. Also, chip macro-morphology was investigated to define the interaction at the tool-chip-workpiece region. The cutting medium affects the surface roughness significantly (more than 100%) for all cutting parameter values. In some environmental cutting conditions, high cutting speed provides 10% lesser surface roughness than low cutting speed parameters. Also, the cutting force decreases by 20% in low feed rate machining conditions. However, the effect of this parameter disappeared for cutting forces in high feed rates and low cutting depth conditions in both MQL and dry environments. Cutting speed was observed as the most influential factor on surface roughness, followed by feed rate. The depth of cut was the main parameter that caused the temperature to increase in the dry machining environment.

Zitieren

APA

Binali, R., Demirpolat, H., Kuntoğlu, M., & Salur, E. (2023). Different Aspects of Machinability in Turning of AISI 304 Stainless Steel: A Sustainable Approach with MQL Technology. Metals, 13(6), 1088. https://doi.org/10.3390/met13061088

Vancouver

Binali R, Demirpolat H, Kuntoğlu M, Salur E. Different Aspects of Machinability in Turning of AISI 304 Stainless Steel: A Sustainable Approach with MQL Technology. Metals. 2023;13(6):1088. doi:10.3390/met13061088

BibTeX
@article{Binali2023,
  author = {Binali, Rüstem and Demirpolat, Havva and Kuntoğlu, Mustafa and Salur, Emin},
  title = {Different Aspects of Machinability in Turning of AISI 304 Stainless Steel: A Sustainable Approach with MQL Technology},
  journal = {Metals},
  year = {2023},
  volume = {13},
  number = {6},
  pages = {1088},
  doi = {10.3390/met13061088}
}
Kostenlos starten →