Effect of Heat Treatments on Microstructure and Mechanical Properties of Low-Cost Ti-6Al-4V Alloy Produced by Thermomechanical Powder Consolidation Route
Metals · 14.01.2023 · 13 (1) · 173
DOI: 10.3390/met13010173 ↗Kurz gefasst
Fachartikel in der Zeitschrift Metals, online erschienen am 14.01.2023. Verfasst von Ajit Pal Singh und 3 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Business, Innovation, and Employment (MBIE), New Zealand.
Abstract (Originalsprache)
This paper investigates the level of properties enhancement achievable by heat-treating Ti-6Al-4V alloy produced from a blended powder mixture using a thermomechanical powder consolidation route involving warm uniaxial pressing and vacuum sintering followed by extrusion at super transus temperature (1150 °C). The as-extruded material with a higher oxygen content of 0.55 wt.% was subjected to two different sub-transus annealing treatments: HT-A: 955 °C/1 h-furnace cooling and HT-B: 925 °C/4 h-cooling @ 50 °C/h to 760 °C-furnace cooling. Room temperature Charpy v-notch impact toughness tests and tensile tests were performed to ascertain the effect of microstructural changes during post-extrusion annealing treatments. After impact tests, analysis of microstructures and fracture surfaces of samples was carried out using optical and scanning electron microscopy. The as-extruded material displayed mean impact toughness of 4 J along with a yield strength of 956 MPa, an ultimate tensile strength of 1150 MPa, and an elongation to fracture of 2.4%. The annealing treatments gave a noticeable enhancement in the impact toughness (average values 5–6 J obtained) while maintaining a yield strength and ultimate tensile strength level of about 992 MPa and 1164–1181 MPa, respectively. Additionally, the level of change in ductility was limited for each sub-transus annealing treatment, and HT-A has given only a 30% increase compared to as-extruded material.
Förderung
- Ministry of Business, Innovation, and Employment (MBIE), New Zealand
Zitieren
APA
Singh, A. P., Torrens, R., Gabbitas, B., & Sivaswamy, G. (2023). Effect of Heat Treatments on Microstructure and Mechanical Properties of Low-Cost Ti-6Al-4V Alloy Produced by Thermomechanical Powder Consolidation Route. Metals, 13(1), 173. https://doi.org/10.3390/met13010173
Vancouver
Singh AP, Torrens R, Gabbitas B, Sivaswamy G. Effect of Heat Treatments on Microstructure and Mechanical Properties of Low-Cost Ti-6Al-4V Alloy Produced by Thermomechanical Powder Consolidation Route. Metals. 2023;13(1):173. doi:10.3390/met13010173
BibTeX
@article{Singh2023,
author = {Singh, Ajit Pal and Torrens, Rob and Gabbitas, Brian and Sivaswamy, Giribaskar},
title = {Effect of Heat Treatments on Microstructure and Mechanical Properties of Low-Cost Ti-6Al-4V Alloy Produced by Thermomechanical Powder Consolidation Route},
journal = {Metals},
year = {2023},
volume = {13},
number = {1},
pages = {173},
doi = {10.3390/met13010173}
}
EUVIMED