EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Topology and Size Optimization for Mill Relining Manipulator Under Multiple Operating Conditions

Pengju Jiao, Mingyuan Wang, Yujun Xue, Yunhua Bai, Zhengguo Wang, Yongjian Yu

Machines · 16.04.2026 · 14 (4) · 441

DOI: 10.3390/machines14040441 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Machines, online erschienen am 16.04.2026. Verfasst von Pengju Jiao und 5 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Key Research and Development Special Project of Henan Province, China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Mill relining manipulator is essential maintenance equipment used to replace liners in a grinding mill. However, its excessive structural weight significantly constrains maneuverability and operational efficiency. To address this problem, this paper proposed a lightweight design framework for the manipulator’s upper arm, integrating improved multiple operating conditions topology optimization with size optimization. Firstly, a finite element model of the manipulator was established in ANSYS Workbench 2022R2. The loads under the corresponding operating conditions were extracted and applied to the finite element model of the upper arm to perform multi-condition finite element simulations. Secondly, a mathematical model for multi-condition topology optimization was developed using the variable density method combined with the Analytic Hierarchy Process (AHP), and the weight coefficients for each operating condition were determined. Finally, a combined response surface methodology (RSM) and genetic algorithm (GA) approach was employed to optimize the structural parameters of the upper arm. A response surface model with maximum equivalent stress and maximum deformation as the response variables was constructed, and the Pareto optimal set was obtained using the non-dominated sorting genetic algorithm (NSGA-II) to determine the optimal structural design. Quasi-static load tests were conducted on a scaled prototype to verify the reliability of the numerical optimization results. The results demonstrate that the optimized upper arm satisfies the strength and stiffness requirements while achieving a 12% mass reduction (2463 kg), confirming the effectiveness and engineering applicability of the proposed lightweight design methodology.

Förderung

  • Key Research and Development Special Project of Henan Province, China

Zitieren

APA

Jiao, P., Wang, M., Xue, Y., Bai, Y., Wang, Z., & Yu, Y. (2026). Topology and Size Optimization for Mill Relining Manipulator Under Multiple Operating Conditions. Machines, 14(4), 441. https://doi.org/10.3390/machines14040441

Vancouver

Jiao P, Wang M, Xue Y, Bai Y, Wang Z, Yu Y. Topology and Size Optimization for Mill Relining Manipulator Under Multiple Operating Conditions. Machines. 2026;14(4):441. doi:10.3390/machines14040441

BibTeX
@article{Jiao2026,
  author = {Jiao, Pengju and Wang, Mingyuan and Xue, Yujun and Bai, Yunhua and Wang, Zhengguo and Yu, Yongjian},
  title = {Topology and Size Optimization for Mill Relining Manipulator Under Multiple Operating Conditions},
  journal = {Machines},
  year = {2026},
  volume = {14},
  number = {4},
  pages = {441},
  doi = {10.3390/machines14040441}
}
Kostenlos starten →