Study on Polymer Damping Technology for Mountain Tunnels in Strong Earthquake-Prone Areas
Materials · 18.11.2026 · 19 (22) · 4884
DOI: 10.3390/ma19224884 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 18.11.2026. Verfasst von Bo Sun und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Major Science and Technology Project of Henan Province.
Abstract (Originalsprache)
To address the seismic challens faced by mountain tunnels in earthquake-prone areas, this study proposes a novel integrated seismic mitigation and anti-seepage solution using a non-water-reactive two-component foamed polymer to directly replace conventional waterproof boards. Compared with traditional damping materials, this material offers the advantages of light weight, high toughness, excellent impermeability, long-term stability and convenient construction. The effects of the configuration, location, thickness, and density of the polymer damping layer on its damping performance were investigated through dynamic nonlinear time-history analysis using an implicit integration method. The results show that a full-section polymer damping layer installed between the primary and secondary linings exhibited the best performance. Under bidirectional seismic excitations, the peak maximum principal stress, peak minimum principal stress, and plastic zone area of the tunnel lining were reduced by an average of 53%, 55% and 47%, respectively. With increasing damping layer thickness, the damping effect increased rapidly and then became relatively stable. As the density of the damping layer increased, the seismic dynamic response of the tunnel lining exhibited three-stage characteristics, namely, a relatively stable stage, a rapid-growth stage, and a slow-growth stage. For a specific tunnel project, considering both the seismic mitigation effect and economic efficiency, a density of 150–250 kg/m3 and a thickness of approximately 0.10 m are recommended for the damping layer. According to different surrounding rock grades (III–V) and seismic fortification intensities (8–9), design schemes and recommended parameters for the polymer damping layer in the composite lining of mountain tunnels are proposed. Furthermore, a spraying construction technique for the polymer damping layer is proposed and demonstrated in a tunnel project.
Förderung
- Major Science and Technology Project of Henan Province
Zitieren
APA
Sun, B., Liu, R., & Zhang, G. (2026). Study on Polymer Damping Technology for Mountain Tunnels in Strong Earthquake-Prone Areas. Materials, 19(22), 4884. https://doi.org/10.3390/ma19224884
Vancouver
Sun B, Liu R, Zhang G. Study on Polymer Damping Technology for Mountain Tunnels in Strong Earthquake-Prone Areas. Materials. 2026;19(22):4884. doi:10.3390/ma19224884
BibTeX
@article{Sun2026,
author = {Sun, Bo and Liu, Rui and Zhang, Ge},
title = {Study on Polymer Damping Technology for Mountain Tunnels in Strong Earthquake-Prone Areas},
journal = {Materials},
year = {2026},
volume = {19},
number = {22},
pages = {4884},
doi = {10.3390/ma19224884}
}
EUVIMED