The Influence of SiC and Al2O3 Particles on the Microstructure and Tribological Properties of the EN-GJL-150 Cast Iron-Based Composite
Materials · 13.05.2026 · 19 (10) · 2040
DOI: 10.3390/ma19102040 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 13.05.2026. Verfasst von Jaroslaw Piatkowski und 3 weiteren Autor:innen. Beteiligte Einrichtung: Materials Innovation Laboratory, Faculty of Materials Science and Industrial Digitalization, Silesian University of Technology, Krasinskiego 8, 40-01…. Die Arbeit nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the Excellence Initiative-Research University (IBUD) programme implemented at the Silesian University of Technology, the Excellence Initiative—Research University (IBUD) programme implemented at the Silesian University of Technology.
Abstract (Originalsprache)
This article presents preliminary research on the development of a cast iron–ceramic composite for modern braking systems, such as brake discs. The composite matrix is gray cast iron with flake graphite (EN-GJL-150). The reinforcing phase is a porous ceramic composed of SiC and Al2O3 particles introduced separately (10% each) and together (70% SiC + 30% Al2O3). These particles were applied as a suspension onto polyurethane foam, yielding a ceramic structure with a pore density of up to 10 ppi. The resulting insert was placed in a mold cavity, and cast iron was poured into it. The resulting samples were treated as brake disc material, with a pad made of the commercial friction material P50094 serving as the countersample. Tribological tests showed that the lowest sample wear (average 2.23 mg/5000 m) was achieved for the composite reinforced with SiC + Al2O3 particles. This is probably due to the synergy between the antifriction properties of these particles and the lower friction coefficient (µ = 0.180–0.22). Similar mass loss values and the smallest difference between the tested samples were observed for composites with SiC particles (3.01 mg/5000 m) and Al2O3 (3.30 mg/5000 m). The second part consisted of microstructural studies. Microstructural analysis of the EN-GJL-150 + SiC + Al2O3 composite revealed a previously unobserved nucleation phenomenon at the cast iron–ceramic interface. This confirmed the general assumptions of Riposan’s theory regarding the involvement of oxide microinclusions and complex manganese sulfides of the (Mn, X)S type in the nucleation and crystallization of graphite precipitates. It was also found that, in the case of “in situ” GJL-150 + SiC + Al2O3 composites, this theory should account for the beneficial role of ceramic particles in promoting the uniform distribution of type A graphite flakes, which nucleate on their surfaces in the transition zone. Thus, the nucleating role of oxide microinclusions (the first stage of Riposan’s theory) could be taken over by SiC and Al2O3 particles, constituting a substrate for the heterogeneous nucleation of (Mn, X)S sulfides.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Materials Innovation Laboratory, Faculty of Materials Science and Industrial Digitalization, Silesian University of Technology, Krasinskiego 8, 40-019 Katowice, Poland.
- Independent Researcher, 43-600 Jaworzno, Poland.
- Department of Metallurgy and Recycling, Faculty of Materials Science and Industrial Digitalization, Silesian University of Technology, Krasinskiego 8, 40-019 Katowice, Poland.
- Department of Applied Geology, Faculty of Mining, Safety Engineering and Industrial Automation, Silesian University of Technology, ul. Akademicka 2, 41-100 Gliwice, Poland.
ORCID-Profile: Jaroslaw Piatkowski, Tomasz Matula, Katarzyna Nowinska
Förderung
- the Excellence Initiative-Research University (IBUD) programme implemented at the Silesian University of Technology
- the Excellence Initiative—Research University (IBUD) programme implemented at the Silesian University of Technology
Zitieren
APA
Piatkowski, J., Wojciechowski, M., Matula, T., & Nowinska, K. (2026). The Influence of SiC and Al2O3 Particles on the Microstructure and Tribological Properties of the EN-GJL-150 Cast Iron-Based Composite. Materials, 19(10), 2040. https://doi.org/10.3390/ma19102040
Vancouver
Piatkowski J, Wojciechowski M, Matula T, Nowinska K. The Influence of SiC and Al2O3 Particles on the Microstructure and Tribological Properties of the EN-GJL-150 Cast Iron-Based Composite. Materials. 2026;19(10):2040. doi:10.3390/ma19102040
BibTeX
@article{Piatkowski2026,
author = {Piatkowski, Jaroslaw and Wojciechowski, Mateusz and Matula, Tomasz and Nowinska, Katarzyna},
title = {The Influence of SiC and Al2O3 Particles on the Microstructure and Tribological Properties of the EN-GJL-150 Cast Iron-Based Composite},
journal = {Materials},
year = {2026},
volume = {19},
number = {10},
pages = {2040},
doi = {10.3390/ma19102040}
}
EUVIMED