EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Tribocorrosion Behavior of Mg Alloys on Sliding Friction in Hank’s Balanced Salt Solution

Eri Miura iD, Chihiro Shiraishi, Sachiko Hiromoto

Materials · 09.04.2026 · 19 (8) · 1513

DOI: 10.3390/ma19081513 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 09.04.2026. Verfasst von Eri Miura und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Materials and Synchrotron Radiation Engineering, Graduate School of Engineering, University of Hyogo, 2167 Shosha, Himeji 671-2280, Hyo…. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 55 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Inter-University Cooperative Research Program of the Institute for Materials Research (IMR), Tohoku University, Cooperative Research Project of the Research Center for Biomedical Engineering, Institute for Materials Research, Tohoku University.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The tribocorrosion behavior of AZ31 and WE43 was investigated during sliding wear tests in Hank’s balanced salt solution (HBSS) and pure water. While wear volume increased monotonically with load in air and water, HBSS exhibited a distinct non-monotonic trend; the maximum material loss occurred at the minimum load (0.98 N) and decreased at 2.94 N before rising again. This indicates that at low loads, degradation is primarily driven by accelerated chemical dissolution (tribocorrosion) rather than by purely mechanical abrasion. The magnitude of wear followed the order [HBSS] > [air] > [water] in the low-load range (0.98–1.96 N), whereas it shifted to [air] > [HBSS] > [water] in the high-load range (2.94–5.88 N). A comparison of the wear rate of the alloys shows that the wear rate in HBSS differs from that in water, depending on the hardness of the substrate, similar to conditions in air. Notably, the specific wear rate decreased as test duration increased under low loads, further suggesting that corrosion-induced volume loss significantly outweighs mechanical wear in this regime. The static corrosion test revealed that volume loss during tribocorrosion was higher than that under static corrosion conditions. While the deposition of corrosion products affected net volume loss, chemical dissolution remained the primary driver of the observed wear trends at low loads. Electrochemical data from anodic polarization curves confirmed that the specimen tested under a 0.98 N load exhibited lower corrosion resistance. Mechanistically, it was suggested that Cl− ions contributed to the overall increase in wear, while NaHCO3 specifically contributed to the increase in wear in the low-load range.

Schlagwörter

Stichwörter der Autor:innen

biomaterialcrevice corrosionmagnesium alloyssliding weartribocorrosion

Autor:innen und Institutionen

  • Department of Materials and Synchrotron Radiation Engineering, Graduate School of Engineering, University of Hyogo, 2167 Shosha, Himeji 671-2280, Hyogo, Japan.
  • Research Center for Structural Materials, National Institute for Materials Science (NIMS), 1-2-1 Sengen, Tsukuba 305-0047, Ibaraki, Japan.

ORCID-Profile: Eri Miura

Förderung

  • Inter-University Cooperative Research Program of the Institute for Materials Research (IMR), Tohoku University
  • Cooperative Research Project of the Research Center for Biomedical Engineering
  • Institute for Materials Research, Tohoku University

Zitieren

APA

Miura, E., Shiraishi, C., & Hiromoto, S. (2026). Tribocorrosion Behavior of Mg Alloys on Sliding Friction in Hank’s Balanced Salt Solution. Materials, 19(8), 1513. https://doi.org/10.3390/ma19081513

Vancouver

Miura E, Shiraishi C, Hiromoto S. Tribocorrosion Behavior of Mg Alloys on Sliding Friction in Hank’s Balanced Salt Solution. Materials. 2026;19(8):1513. doi:10.3390/ma19081513

BibTeX
@article{Miura2026,
  author = {Miura, Eri and Shiraishi, Chihiro and Hiromoto, Sachiko},
  title = {Tribocorrosion Behavior of Mg Alloys on Sliding Friction in Hank’s Balanced Salt Solution},
  journal = {Materials},
  year = {2026},
  volume = {19},
  number = {8},
  pages = {1513},
  doi = {10.3390/ma19081513}
}
Kostenlos starten →