EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Process Temperature Control for Low Dishing in CMP

Yeongil Shin iD, Jongmin Jeong, Jiho Shin, Haedo Jeong iD

Materials · 24.09.2025 · 18 (19) · 4461

DOI: 10.3390/ma18194461 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 24.09.2025. Verfasst von Yeongil Shin und 3 weiteren Autor:innen. Beteiligte Einrichtung: Graduated School of Mechanical Engineering, Pusan National University, Busan 46703, Republic of Korea. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Growing demand for high-performance system semiconductors has highlighted the importance of hybrid bonding, where precise control of copper dishing is essential. This requirement reinforces the role of chemical mechanical planarization (CMP). Many studies have sought to control dishing by modifying slurry chemistry or adjusting mechanical parameters, but these approaches have not been sufficient. This study addresses the overlooked effect of process temperature and demonstrates its role in integrating both chemical and mechanical behaviors in CMP. Removal rates of Cu, Ta, and SiO2 films were evaluated through blanket wafer experiments, and all exhibited Arrhenius-type behavior as a function of temperature and activation energy. The results showed that maintaining the process temperature at 30 °C balanced selectivity and minimized dishing on patterned wafers. To enable precise temperature control, a vortex-tube-based pad cooling system was developed. Without temperature control, dishing increased by 12 nm in the 100 µm pattern and 16 nm in the 50 µm pattern. With temperature control, dishing was reduced to 4 nm and below 1 nm, respectively. These results demonstrate that process temperature is a key parameter for controlling selectivity and ensuring precise dishing control, which is critical to meeting the requirements of hybrid bonding.

Schlagwörter

Stichwörter der Autor:innen

chemical mechanical planarization (CMP)dishingpad cooling systemselectivitytemperaturevortex tube

Autor:innen und Institutionen

  • Graduated School of Mechanical Engineering, Pusan National University, Busan 46703, Republic of Korea.

ORCID-Profile: Yeongil Shin, Haedo Jeong

Zitieren

APA

Shin, Y., Jeong, J., Shin, J., & Jeong, H. (2025). Process Temperature Control for Low Dishing in CMP. Materials, 18(19), 4461. https://doi.org/10.3390/ma18194461

Vancouver

Shin Y, Jeong J, Shin J, Jeong H. Process Temperature Control for Low Dishing in CMP. Materials. 2025;18(19):4461. doi:10.3390/ma18194461

BibTeX
@article{Shin2025,
  author = {Shin, Yeongil and Jeong, Jongmin and Shin, Jiho and Jeong, Haedo},
  title = {Process Temperature Control for Low Dishing in CMP},
  journal = {Materials},
  year = {2025},
  volume = {18},
  number = {19},
  pages = {4461},
  doi = {10.3390/ma18194461}
}
Kostenlos starten →