Experimental and Numerical Investigations on the Influences of Target Porosity and w/c Ratio on Strength and Permeability of Pervious Concrete
Materials · 22.08.2025 · 18 (17) · 3951
DOI: 10.3390/ma18173951 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 22.08.2025. Verfasst von Fei Liu und 7 weiteren Autor:innen. Beteiligte Einrichtung: School of Civil and Transportation Engineering, Beijing University of Civil Engineering and Architecture, Beijing 102616, China. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 56 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, China Postdoctoral Science Foundation, Hebei Natural Science Foundation.
Abstract (Originalsprache)
Pervious concrete is a promising sustainable pavement material for sponge city construction. The incorporation of Steel Slag Aggregate (SSA) as a substitute for natural aggregates has the double role of clean production with significant economic and environmental benefits. While the strength and permeability, known as two critical design parameters of pervious concrete, are closely linked to its porosity, there is limited research on the influence of the porosity on the mechanical properties of pervious concrete. In this paper, both experimental and numerical investigations were performed, focusing on the influence of target porosity on the strength and permeability of pervious concrete with and without SSA. Three different target porosities (15%, 20%, and 25%), five distinct water-to-cement (w/c) ratios (0.25, 0.28, 0.30, 0.33, and 0.35), and five SSA replacement ratios (0, 25%, 50%, 75%, and 100%) were considered in this study. A two-dimensional (2D) finite-element (FE) model was developed, with which the failure mode and the strength variation of pervious concrete under different target porosities were analyzed and verified with the experimental results. The results showed that the porosity had a significant influence on both the strength and permeability of pervious concrete, while the influence of the w/c ratio is marginal. There existed an optimal w/c ratio of 0.3, for which pervious concrete with porosities of 15%, 20%, and 25% achieved 28-day compressive strengths of 27.8, 20.6, and 15.6 MPa and permeability coefficients of 0.32, 0.58, and 1.02 cm/s, respectively. Specifically, at the lowest porosity of 15%, the replacement of 100% SSA resulted in the largest improvement in the compressive strength up to 37.86%. Based on the regression analysis, a series of empirical equations correlating the porosity, strength and permeability of pervious concrete was formulated and validated against the experimental data. The findings presented herein are expected to provide references to the practical evaluation of the optimal mix proportion of previous concrete, considering specific and demanding engineering requirements.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Civil and Transportation Engineering, Beijing University of Civil Engineering and Architecture, Beijing 102616, China.
- School of Economics and Management, Jilin Jianzhu University, Changchun 130118, China.
- School of Engineering, Design and Built Environment, Western Sydney University, Kingswood, NSW 2751, Australia.
- School of Civil Engineering, Hebei University of Engineering, Handan 056038, China.
ORCID-Profile: Mengyuan Zhu
Förderung
- National Natural Science Foundation of China
- China Postdoctoral Science Foundation
- Hebei Natural Science Foundation
- China Scholarship Council
Zitieren
APA
Liu, F., Li, Z., Liu, B., Yu, Z., Li, Z., Zhu, M., Wang, Y., & Ding, X. (2025). Experimental and Numerical Investigations on the Influences of Target Porosity and w/c Ratio on Strength and Permeability of Pervious Concrete. Materials, 18(17), 3951. https://doi.org/10.3390/ma18173951
Vancouver
Liu F, Li Z, Liu B, Yu Z, Li Z, Zhu M, et al. Experimental and Numerical Investigations on the Influences of Target Porosity and w/c Ratio on Strength and Permeability of Pervious Concrete. Materials. 2025;18(17):3951. doi:10.3390/ma18173951
BibTeX
@article{Liu2025,
author = {Liu, Fei and Li, Zhe and Liu, Bowen and Yu, Zhuohui and Li, Zetong and Zhu, Mengyuan and Wang, Yanjie and Ding, Xizhou},
title = {Experimental and Numerical Investigations on the Influences of Target Porosity and w/c Ratio on Strength and Permeability of Pervious Concrete},
journal = {Materials},
year = {2025},
volume = {18},
number = {17},
pages = {3951},
doi = {10.3390/ma18173951}
}
EUVIMED