EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Enhancement of Cu-Cu Bonding Interfaces Through High Creep Rate in Nanocrystalline Cu

Jian-Yuan Huang iD, Dinh-Phuc Tran iD, Kang-Ping Lee, Yi-Quan Lin, Emile Kuo, Tsung-Chuan Chen, Yao-Tsung Chen, Stream Chung, Chih Chen iD

Materials · 08.08.2025 · 18 (16) · 3725

DOI: 10.3390/ma18163725 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 08.08.2025. Verfasst von Jian-Yuan Huang und 8 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Pioneer Semiconductor Innovation, National Yang Ming Chiao Tung University, Hsinchu 300093, Taiwan. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science and Technology Council, Taiwan, Center for Advanced Semiconductor Technology Research under Higher Education Sprout Project of Ministry of Education, Taiwan, Semiconductor Research Corporation (SRC), USA.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the use of nanocrystalline Cu (NC-Cu) to suppress interfacial voids in low-temperature Cu-Cu bonding for 3D IC packaging. We quantitatively compared the void characteristics of electrodeposited NC-Cu (grain size ~89.3 nm) and (111)-oriented nanotwinned Cu (NT-Cu, ~621.8 nm) bonded at 200 °C. Plan-view STEM-HAADF analysis revealed that NC-Cu achieved a much lower void area ratio (1.8%) than NT-Cu (4.0%), attributed to its high grain boundary density, which enhances atomic diffusion and grain boundary migration. At 250 °C, typical Ostwald ripening was observed, with fewer but larger voids. However, a rise in total void area fraction suggests a competing mechanism—possibly new void nucleation at grain boundaries triggered by residual defects from the electroplating process. These results highlight the superior void-mitigating capability of NC-Cu under low thermal budgets.

Schlagwörter

Stichwörter der Autor:innen

3D ICCu-Cu bondinginterfacial voidsnanocrystalline Cuplan-view STEM

Autor:innen und Institutionen

  • Institute of Pioneer Semiconductor Innovation, National Yang Ming Chiao Tung University, Hsinchu 300093, Taiwan.
  • Department of Materials Science and Engineering, National Yang Ming Chiao Tung University, Hsinchu 300093, Taiwan.
  • Chemleaders Inc., Hsinchu 303036, Taiwan.

ORCID-Profile: Jian-Yuan Huang, Dinh-Phuc Tran, Chih Chen

Förderung

  • National Science and Technology Council, Taiwan
  • Center for Advanced Semiconductor Technology Research under Higher Education Sprout Project of Ministry of Education, Taiwan
  • Semiconductor Research Corporation (SRC), USA

Zitieren

APA

Huang, J. Y., Tran, D. P., Lee, K. P., Lin, Y. Q., Kuo, E., Chen, T. C., Chen, Y. T., Chung, S., & Chen, C. (2025). Enhancement of Cu-Cu Bonding Interfaces Through High Creep Rate in Nanocrystalline Cu. Materials, 18(16), 3725. https://doi.org/10.3390/ma18163725

Vancouver

Huang JY, Tran DP, Lee KP, Lin YQ, Kuo E, Chen TC, et al. Enhancement of Cu-Cu Bonding Interfaces Through High Creep Rate in Nanocrystalline Cu. Materials. 2025;18(16):3725. doi:10.3390/ma18163725

BibTeX
@article{Huang2025,
  author = {Huang, Jian-Yuan and Tran, Dinh-Phuc and Lee, Kang-Ping and Lin, Yi-Quan and Kuo, Emile and Chen, Tsung-Chuan and Chen, Yao-Tsung and Chung, Stream and Chen, Chih},
  title = {Enhancement of Cu-Cu Bonding Interfaces Through High Creep Rate in Nanocrystalline Cu},
  journal = {Materials},
  year = {2025},
  volume = {18},
  number = {16},
  pages = {3725},
  doi = {10.3390/ma18163725}
}
Kostenlos starten →