EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Preparation and Properties of Environmentally Friendly Carboxyl Graphene Oxide/Silicone Coatings

Zhenhua Chu iD, Jiahao Lu, Wan Tang, Yuchen Xu, Quantong Jiang, Jingxiang Xu iD

Materials · 05.05.2025 · 18 (9) · 2122

DOI: 10.3390/ma18092122 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 05.05.2025. Verfasst von Zhenhua Chu und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Mechanical Engineering, College of Engineering, Shanghai Ocean University, Shanghai 201306, China. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Nature Science Foundation of China, National Nature Science Foundation of Shanghai.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To address the protective demands of marine engineering equipment in complex corrosive environments, this study proposes an environmentally friendly composite coating based on carboxylated graphene oxide (CGO)-modified water-based epoxy organosilicon resin. By incorporating varying mass fractions (0.05–0.25%) of CGO into the resin matrix via mechanical blending, the microstructure, corrosion resistance, and long-term corrosion kinetics of the coatings were systematically investigated. The results demonstrate that the coating with 0.15 wt.% CGO (designated as KCG15) exhibited optimal comprehensive performance: its corrosion current density (Icorr = 4.37 × 10−8 A/cm2) was two orders of magnitude lower than that of the pure resin coating, while its low-frequency impedance modulus (∣Z∣0.1Hz = 4.99 × 106 Ω⋅cm2) is significantly enhanced, accompanied by improved surface compactness. The coating achieved a 97% inhibition rate against sulfate-reducing bacteria (SRB) through synergistic physical disruption and electrostatic repulsion mechanisms. Long-term corrosion kinetics analysis via 60-day seawater immersion identified three degradation phases—permeation (0–1 day), blockage (1–4 days), and failure (7–60 days)—with structural evolution from microcrack networks to foam-like blistering ultimately reducing by 97.8%. Furthermore, a 180-day atmospheric exposure test confirms the superior weatherability and adhesion of the KCG15 coating, with only minor discoloration observed due to its hydrophobic surface. This work provides theoretical and technical foundations for developing marine anti-corrosion coatings that synergize environmental sustainability with long-term protective performance.

Schlagwörter

Stichwörter der Autor:innen

anti-corrosionantifouling coatingcarboxyl graphene oxidesilicone resin

Autor:innen und Institutionen

  • Department of Mechanical Engineering, College of Engineering, Shanghai Ocean University, Shanghai 201306, China.
  • CAS Key Laboratory of Marine Environmental Corrosion and Bio-Fouling, Institute of Oceanology, Chinese Academy of Sciences, Qingdao 266404, China.

ORCID-Profile: Zhenhua Chu, Jingxiang Xu

Förderung

  • National Nature Science Foundation of China
  • National Nature Science Foundation of Shanghai

Zitieren

APA

Chu, Z., Lu, J., Tang, W., Xu, Y., Jiang, Q., & Xu, J. (2025). Preparation and Properties of Environmentally Friendly Carboxyl Graphene Oxide/Silicone Coatings. Materials, 18(9), 2122. https://doi.org/10.3390/ma18092122

Vancouver

Chu Z, Lu J, Tang W, Xu Y, Jiang Q, Xu J. Preparation and Properties of Environmentally Friendly Carboxyl Graphene Oxide/Silicone Coatings. Materials. 2025;18(9):2122. doi:10.3390/ma18092122

BibTeX
@article{Chu2025,
  author = {Chu, Zhenhua and Lu, Jiahao and Tang, Wan and Xu, Yuchen and Jiang, Quantong and Xu, Jingxiang},
  title = {Preparation and Properties of Environmentally Friendly Carboxyl Graphene Oxide/Silicone Coatings},
  journal = {Materials},
  year = {2025},
  volume = {18},
  number = {9},
  pages = {2122},
  doi = {10.3390/ma18092122}
}
Kostenlos starten →