EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Optimisation of Hot-Chamber Die-Casting Process of AM60 Alloy Using Taguchi Method

Tomasz Rzychoń, Andrzej Kiełbus iD

Materials · 21.12.2024 · 17 (24) · 6256

DOI: 10.3390/ma17246256 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 21.12.2024. Verfasst von Tomasz Rzychoń und 1 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Materials Engineering, Silesian University of Technology, ul. Krasińskiego 8, 40-019 Katowice, Poland. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Polish Ministry of Science and Higher Education.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents the effect of hot-chamber HPDC (high-pressure die casting) process parameters on the porosity, mechanical properties, and microstructure of AM60 magnesium alloy. To reduce costs, a Taguchi design of the experimental method was used to optimise the HPDC process. Six parameters set at two levels were selected for optimisation, i.e., piston speed in the first phase, piston speed in the second phase, molten metal temperature, piston travel, mould temperature, and die-casting pressure (the pressure under the piston). Signal-to-noise (S/N) ratios were used to quantify the present variations. The significance of the influence of the HPDC parameters was assessed using statistical analysis of variance (ANOVA). The results showed that the die-casting pressure had the most significant influence on the porosity of the AM60 alloy. Moreover, piston speed in the first phase, second phase, and die-casting pressure had the most important effects on tensile strength. It is well known that porosity determines the mechanical properties of die castings; however, in AM60 alloy, changes in the HPDC parameters also contribute to microstructural changes, mainly through the formation of Externally Solidified Crystals.

Schlagwörter

Stichwörter der Autor:innen

AM60Taguchihot-chamber die casting

Autor:innen und Institutionen

  • Faculty of Materials Engineering, Silesian University of Technology, ul. Krasińskiego 8, 40-019 Katowice, Poland.

ORCID-Profile: Andrzej Kiełbus

Förderung

  • Polish Ministry of Science and Higher Education

Zitieren

APA

Rzychoń, T., & Kiełbus, A. (2024). Optimisation of Hot-Chamber Die-Casting Process of AM60 Alloy Using Taguchi Method. Materials, 17(24), 6256. https://doi.org/10.3390/ma17246256

Vancouver

Rzychoń T, Kiełbus A. Optimisation of Hot-Chamber Die-Casting Process of AM60 Alloy Using Taguchi Method. Materials. 2024;17(24):6256. doi:10.3390/ma17246256

BibTeX
@article{Rzycho2024,
  author = {Rzychoń, Tomasz and Kiełbus, Andrzej},
  title = {Optimisation of Hot-Chamber Die-Casting Process of AM60 Alloy Using Taguchi Method},
  journal = {Materials},
  year = {2024},
  volume = {17},
  number = {24},
  pages = {6256},
  doi = {10.3390/ma17246256}
}
Kostenlos starten →