EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Impact of hBN Content on the Tribological Behavior and Thermal Diffusivity of HVOF-Sprayed Cr3C2-NiCr Coatings

Julian Eßler, Dino Woelk, Ion-Dragos Utu iD, Gabriela Marginean iD

Materials · 09.11.2024 · 17 (22) · 5470

DOI: 10.3390/ma17225470 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 09.11.2024. Verfasst von Julian Eßler und 3 weiteren Autor:innen. Beteiligte Einrichtung: Materials and Manufacturing Engineering Department, Faculty of Mechanical Engineering, Politehnica University of Timișoara, Bvd. Mihai Viteazu nr. 1,…. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Considering the significant health risks posed by hard chrome plating during its application, thermally sprayed Cr3C2-NiCr cermet coatings represent a suitable alternative. Incorporating hexagonal boron nitride (hBN) as a dry lubricant into the feedstock powder can further enhance wear resistance and thermal conductivity, crucial for preventing premature failure caused by inadequate lubrication. In this study, the mass fraction of hBN was varied between 0 and 15 wt.% to assess its influence on the tribological performance of the coatings using pin-on-disk tests. The coating’s hardness was measured via the Vickers method, and its cracking tendency at the coating/substrate interface was evaluated. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) were employed to analyze the microstructure and phase composition, while thermal diffusivity was determined using the laser flash method. The findings revealed that the inclusion of hBN, at concentrations of up to 10 wt.%, leads to an improvement in thermal diffusivity and a reduction in the coefficient of friction. However, exceeding this threshold leads to a decrease in hardness and increased crack formation tendency, highlighting the trade-off between frictional and mechanical properties.

Schlagwörter

Stichwörter der Autor:innen

Cr3C2-NiCrHVOFboron nitride composite coatingssliding wearthermal diffusivity

Autor:innen und Institutionen

  • Materials and Manufacturing Engineering Department, Faculty of Mechanical Engineering, Politehnica University of Timișoara, Bvd. Mihai Viteazu nr. 1, 300222 Timișoara, Romania.
  • Institute of Mechanical Engineering, Westphalian University of Applied Sciences, Neidenburgerstr. 43, 45897 Gelsenkirchen, Germany.

ORCID-Profile: Ion-Dragos Utu, Gabriela Marginean

Zitieren

APA

Eßler, J., Woelk, D., Utu, I. D., & Marginean, G. (2024). Impact of hBN Content on the Tribological Behavior and Thermal Diffusivity of HVOF-Sprayed Cr3C2-NiCr Coatings. Materials, 17(22), 5470. https://doi.org/10.3390/ma17225470

Vancouver

Eßler J, Woelk D, Utu ID, Marginean G. Impact of hBN Content on the Tribological Behavior and Thermal Diffusivity of HVOF-Sprayed Cr3C2-NiCr Coatings. Materials. 2024;17(22):5470. doi:10.3390/ma17225470

BibTeX
@article{Eler2024,
  author = {Eßler, Julian and Woelk, Dino and Utu, Ion-Dragos and Marginean, Gabriela},
  title = {Impact of hBN Content on the Tribological Behavior and Thermal Diffusivity of HVOF-Sprayed Cr3C2-NiCr Coatings},
  journal = {Materials},
  year = {2024},
  volume = {17},
  number = {22},
  pages = {5470},
  doi = {10.3390/ma17225470}
}
Kostenlos starten →