EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Physico-Chemical Properties of Copper-Doped Hydroxyapatite Coatings Obtained by Vacuum Deposition Technique

Yassine Benali iD, Daniela Predoi, Krzysztof Rokosz iD, Carmen Steluta Ciobanu iD, Simona Liliana Iconaru iD, Steinar Raaen, Catalin Constantin Negrila, Carmen Cimpeanu, Roxana Trusca, Liliana Ghegoiu, Coralia Bleotu iD, Ioana Cristina Marinas iD und 2 weitere

Materials · 25.07.2024 · 17 (15) · 3681

DOI: 10.3390/ma17153681 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 25.07.2024. Verfasst von Yassine Benali und 13 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Sciences, University de Gafsa, Route de Tozeur, Gafsa 2112, Tunisia. Die Arbeit wurde bisher 18-mal zitiert (Crossref) und nennt 80 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Unitatea Executiva Pentru Finantarea Invatamantului Superior a Cercetarii Dezvoltarii si Inovarii, Core Program of the National Institute of Materials Physics.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The hydroxyapatite and copper-doped hydroxyapatite coatings (Ca10−xCux(PO4)6(OH)2; xCu = 0, 0.03; HAp and 3CuHAp) were obtained by the vacuum deposition technique. Then, both coatings were analyzed by the X-ray diffraction (XRD), scanning electron microscopy (SEM), atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS), Fourier transform infrared spectroscopy (FTIR) and water contact angle techniques. Information regarding the in vitro antibacterial activity and biological evaluation were obtained. The XRD studies confirmed that the obtained thin films consist of a single phase associated with hydroxyapatite (HAp). The obtained 2D and 3D SEM images did not show cracks or other types of surface defects. The FTIR studies’ results proved the presence of vibrational bands characteristic of the hydroxyapatite structure in the studied coating. Moreover, information regarding the HAp and 3CuHAp surface wettability was obtained by water contact angle measurements. The biocompatibility of the HAp and 3CuHAp coatings was evaluated using the HeLa and MG63 cell lines. The cytotoxicity evaluation of the coatings was performed by assessing the cell viability through the MTT assay after incubation with the HAp and 3CuHAp coatings for 24, 48, and 72 h. The results proved that the 3CuHAp coatings exhibited good biocompatible activity for all the tested intervals. The ability of Pseudomonas aeruginosa 27853 ATCC (P. aeruginosa) cells to adhere to and develop on the surface of the HAp and 3CuHAp coatings was investigated using AFM studies. The AFM studies revealed that the 3CuHAp coatings inhibited the formation of P. aeruginosa biofilms. The AFM data indicated that P. aeruginosa’s attachment and development on the 3CuHAp coatings were significantly inhibited within the first 24 h. Both the 2D and 3D topographies showed a rapid decrease in attached bacterial cells over time, with a significant reduction observed after 72 h of exposure. Our studies suggest that 3CuHAp coatings could be suitable candidates for biomedical uses such as the development of new antimicrobial agents.

Schlagwörter

Stichwörter der Autor:innen

antimicrobial activitybiocompatibilitycoatingscopper-doped hydroxyapatitevacuum deposition

Autor:innen und Institutionen

  • Faculty of Sciences, University de Gafsa, Route de Tozeur, Gafsa 2112, Tunisia.
  • National Institute of Materials Physics, Atomistilor Street, No. 405A, 077125 Magurele, Romania.
  • Faculty of Electronics and Computer Science, Koszalin University of Technology, Śniadeckich 2, PL 75-453 Koszalin, Poland.
  • Department of Physics, Norwegian University of Science and Technology (NTNU), Realfagbygget E3-124 Høgskoleringen 5, NO 7491 Trondheim, Norway.
  • Faculty of Land Reclamation and Environmental Engineering, University of Agronomic Sciences and Veterinary Medicine of Bucharest, 59 Marasti Blvd, 011464 Bucharest, Romania.
  • National Centre for Micro and Nanomaterials, University Politehnica of Bucharest, 060042 Bucharest, Romania.

ORCID-Profile: Yassine Benali, Krzysztof Rokosz, Carmen Steluta Ciobanu, Simona Liliana Iconaru, Coralia Bleotu, Ioana Cristina Marinas, Miruna Stan

Förderung

  • Unitatea Executiva Pentru Finantarea Invatamantului Superior a Cercetarii Dezvoltarii si Inovarii
  • Core Program of the National Institute of Materials Physics

Zitieren

APA

Benali, Y., Predoi, D., Rokosz, K., Ciobanu, C. S., Iconaru, S. L., Raaen, S., Negrila, C. C., Cimpeanu, C., Trusca, R., Ghegoiu, L., Bleotu, C., Marinas, I. C., Stan, M., & Boughzala, K. (2024). Physico-Chemical Properties of Copper-Doped Hydroxyapatite Coatings Obtained by Vacuum Deposition Technique. Materials, 17(15), 3681. https://doi.org/10.3390/ma17153681

Vancouver

Benali Y, Predoi D, Rokosz K, Ciobanu CS, Iconaru SL, Raaen S, et al. Physico-Chemical Properties of Copper-Doped Hydroxyapatite Coatings Obtained by Vacuum Deposition Technique. Materials. 2024;17(15):3681. doi:10.3390/ma17153681

BibTeX
@article{Benali2024,
  author = {Benali, Yassine and Predoi, Daniela and Rokosz, Krzysztof and Ciobanu, Carmen Steluta and Iconaru, Simona Liliana and Raaen, Steinar and Negrila, Catalin Constantin and Cimpeanu, Carmen and Trusca, Roxana and Ghegoiu, Liliana and Bleotu, Coralia and Marinas, Ioana Cristina and Stan, Miruna and Boughzala, Khaled},
  title = {Physico-Chemical Properties of Copper-Doped Hydroxyapatite Coatings Obtained by Vacuum Deposition Technique},
  journal = {Materials},
  year = {2024},
  volume = {17},
  number = {15},
  pages = {3681},
  doi = {10.3390/ma17153681}
}
Kostenlos starten →