Effects of Laser Defocusing on Bead Geometry in Coaxial Titanium Wire-Based Laser Metal Deposition
Materials · 15.02.2024 · 17 (4) · 889
DOI: 10.3390/ma17040889 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials, online erschienen am 15.02.2024. Verfasst von Remy Mathenia und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Mechanical and Aerospace Engineering, Missouri University of Science and Technology, Rolla, MO 65409, USA. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 17 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: GKN Aerospace, Center for Aerospace Manufacturing Technologies (CAMT), Kummer Innovation and Entrepreneurship Doctoral Fellowship.
Abstract (Originalsprache)
Coaxial wire-based laser metal deposition is a versatile and efficient additive process that can achieve a high deposition rate in the manufacturing of complex structures. In this paper, a three-beam coaxial wire system is studied, with particular attention to the effects of deposition height and laser defocusing on the resulting bead geometry. As the deposition standoff distance changes, so does the workpiece illumination proportion, which describes the ratio of energy going directly into the feedstock wire and into the substrate. Single titanium beads are deposited at varying defocus levels and deposition rates and the bead aspect ratio is measured and analyzed. Over the experimental settings, the defocusing level and deposition rate were found to have a significant effect on the resulting bead aspect ratio. As the defocusing level is increased away from the beam convergence plane, the spot size increases and the deposited track is wider and flatter. Process parameters can be used to tune the deposited material to a desired aspect ratio. In coaxial wire deposition, defocusing provides an adjustment mechanism to the distribution of heat between the wire and substrate and has an important impact on the resulting deposit.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Mechanical and Aerospace Engineering, Missouri University of Science and Technology, Rolla, MO 65409, USA.
- Product Innovation and Engineering, St. James, MO 65559, USA.
ORCID-Profile: Frank Liou
Förderung
- GKN Aerospace
- Center for Aerospace Manufacturing Technologies (CAMT)
- Kummer Innovation and Entrepreneurship Doctoral Fellowship
Zitieren
APA
Mathenia, R., Flood, A., McLain, B., Sparks, T., & Liou, F. (2024). Effects of Laser Defocusing on Bead Geometry in Coaxial Titanium Wire-Based Laser Metal Deposition. Materials, 17(4), 889. https://doi.org/10.3390/ma17040889
Vancouver
Mathenia R, Flood A, McLain B, Sparks T, Liou F. Effects of Laser Defocusing on Bead Geometry in Coaxial Titanium Wire-Based Laser Metal Deposition. Materials. 2024;17(4):889. doi:10.3390/ma17040889
BibTeX
@article{Mathenia2024,
author = {Mathenia, Remy and Flood, Aaron and McLain, Braden and Sparks, Todd and Liou, Frank},
title = {Effects of Laser Defocusing on Bead Geometry in Coaxial Titanium Wire-Based Laser Metal Deposition},
journal = {Materials},
year = {2024},
volume = {17},
number = {4},
pages = {889},
doi = {10.3390/ma17040889}
}
EUVIMED