EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Dissolution Behavior of Lime with Different Properties into Converter Slag

Mengxu Zhang, Jianli Li iD, Cao Jia, Yue Yu

Materials · 29.09.2023 · 16 (19) · 6487

DOI: 10.3390/ma16196487 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 29.09.2023. Verfasst von Mengxu Zhang und 3 weiteren Autor:innen. Beteiligte Einrichtung: The State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology, Wuhan 430081, China. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

China’s 2022 crude steel production soared to an impressive 1.018 billion tons, and steel slag constituted approximately 10% to 15% of this massive output. However, a notable hindrance to the comprehensive utilization of steel slag arises from the fact that it contains 10% to 20% of free calcium oxide (f-CaO), resulting in volume instability. To address this challenge, our study delved into the dynamic transformation of the interface between lime and slag, as well as the fluctuations in the dissolution rate of lime. An Electron Probe Micro Analyzer, equipped with an energy-dispersive spectrometer, was employed for the analysis. Our findings revealed that the configuration of the reaction interface between quicklime and slag underwent alterations throughout various phases of converter smelting. At a temperature of 1400 °C, several significant transformations occurred, including the formation of a CaO-FeO solid solution, (Ca, Mg, Fe) olivine, and low-melting point (Ca, Mg) silicate minerals. With the gradual reduction in FeO content, a robust and high-melting 2CaO·SiO2 layer emerged, generated through the interaction between CaO and (Ca, Mg, Fe) olivine. Furthermore, for lime with a particle size of 20 mm and a calcination rate of 0%, the thickest layer of 2CaO·SiO2 was observed after 120 s of dissolution in slag A2 at 1400 °C. Overall, the dissolution rates of lime with different particle sizes in slag A1 to A4 showed a gradual increase. On the other hand, the dissolution rates of lime with different calcination rates in slag A1 to A4 exhibited an initial increase, followed by a decrease, and then another increase. The formation of a high-melting point and continuous dense 2CaO·SiO2 layer during the dissolution process hindered the mass transfer between lime and slag.

Schlagwörter

Stichwörter der Autor:innen

2CaO·SiO2dissolution ratemass transferproperties of quicklimereaction interface

Autor:innen und Institutionen

  • The State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology, Wuhan 430081, China.
  • Hubei Provincial Key Laboratory for New Processes of Ironmaking and Steelmaking, Wuhan University of Science and Technology, Wuhan 430081, China.

ORCID-Profile: Jianli Li

Förderung

  • National Natural Science Foundation of China
  • State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology

Zitieren

APA

Zhang, M., Li, J., Jia, C., & Yu, Y. (2023). Dissolution Behavior of Lime with Different Properties into Converter Slag. Materials, 16(19), 6487. https://doi.org/10.3390/ma16196487

Vancouver

Zhang M, Li J, Jia C, Yu Y. Dissolution Behavior of Lime with Different Properties into Converter Slag. Materials. 2023;16(19):6487. doi:10.3390/ma16196487

BibTeX
@article{Zhang2023,
  author = {Zhang, Mengxu and Li, Jianli and Jia, Cao and Yu, Yue},
  title = {Dissolution Behavior of Lime with Different Properties into Converter Slag},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {19},
  pages = {6487},
  doi = {10.3390/ma16196487}
}
Kostenlos starten →