EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of Sodium Gluconate on Properties and Microstructure of Ultra-High-Performance Concrete (UHPC)

Yonghua Wu iD, Yibing Yuan iD, Mengdie Niu, Yufeng Kuang

Materials · 07.05.2023 · 16 (9) · 3581

DOI: 10.3390/ma16093581 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials, online erschienen am 07.05.2023. Verfasst von Yonghua Wu und 3 weiteren Autor:innen. Beteiligte Einrichtung: College of Materials Science and Engineering, Xi'an University of Architecture and Technology, Xi'an 710055, China. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Housing Urban-Rural Construction Science and Technology Planning Project from Shaanxi Province, China., Housing Urban-Rural Construction Science and Technology Planning Project.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The properties of concrete can be significantly affected by sodium gluconate (SG) at very small dosages. In this paper, the effects of SG on the fluidity, setting time, heat of hydration, and strength of ultra-high-performance concrete (UHPC) were studied. The results show that (1) in the plastic stage, SG inhibited the formation of early ettringite (AFt) and delayed the hydration of tricalcium silicate (C3S) and dicalcium silicate (C2S). SG increased the initial fluidity of UHPC without decreasing within 1 h. When the SG dosage was ≥0.06%, the slumps at 30 min and 60 min increased slightly. (2) In the setting hardening stage, the addition of SG inhibited the formation of calcium hydroxide (CH), which significantly extended the setting time of UHPC. When the dosage of SG was 0.15%, the initial and final setting times were 5.0 times and 4.5 times that of the blank group, respectively. SG had no obvious effect on the hydration rate of cement in the accelerated period, but the peak hydration temperature of UHPC was increased when the SG dosage was 0.03~0.12%. (3) In the strength development stage, the 1 d and 3 d strength of UHPC decreased significantly with the increase in the SG dosage. However, SG could promote the formation of AFt at the pores and aggregate interface in the later stage, reduce the porosity of cementite, and improve the compressive strength of UHPC in 28 d, 60 d, and 90 d. When the SG dosage was 0.12%, the 90d strength increased by 13%.

Schlagwörter

Stichwörter der Autor:innen

cement hydration acceleration periodcompetitive adsorptioncomplexationheat of hydrationpore structuresodium gluconate (SG)ultra-high-performance concrete (UHPC)

Autor:innen und Institutionen

  • College of Materials Science and Engineering, Xi'an University of Architecture and Technology, Xi'an 710055, China.

ORCID-Profile: Yonghua Wu, Yibing Yuan

Förderung

  • Housing Urban-Rural Construction Science and Technology Planning Project from Shaanxi Province, China.
  • Housing Urban-Rural Construction Science and Technology Planning Project

Zitieren

APA

Wu, Y., Yuan, Y., Niu, M., & Kuang, Y. (2023). Effect of Sodium Gluconate on Properties and Microstructure of Ultra-High-Performance Concrete (UHPC). Materials, 16(9), 3581. https://doi.org/10.3390/ma16093581

Vancouver

Wu Y, Yuan Y, Niu M, Kuang Y. Effect of Sodium Gluconate on Properties and Microstructure of Ultra-High-Performance Concrete (UHPC). Materials. 2023;16(9):3581. doi:10.3390/ma16093581

BibTeX
@article{Wu2023,
  author = {Wu, Yonghua and Yuan, Yibing and Niu, Mengdie and Kuang, Yufeng},
  title = {Effect of Sodium Gluconate on Properties and Microstructure of Ultra-High-Performance Concrete (UHPC)},
  journal = {Materials},
  year = {2023},
  volume = {16},
  number = {9},
  pages = {3581},
  doi = {10.3390/ma16093581}
}
Kostenlos starten →