Anisotropic Wear Resistance of Heat-Treated Selective Laser-Melted 316L Stainless Steel
Lubricants · 19.04.2025 · 13 (4) · 189
DOI: 10.3390/lubricants13040189 ↗Kurz gefasst
Fachartikel in der Zeitschrift Lubricants, online erschienen am 19.04.2025. Verfasst von Menghui Sun und 8 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Research Business Expenses in Inner Mongolia Autonomous Region First-Class Discipline Research Special Project.
Abstract (Originalsprache)
Anisotropic microstructures and wear resistance are caused by large thermal gradients during selective laser melting (SLM). Investigating the wear resistance in different planes of SLM specimens is crucial. Hence, the effect of heat treatment on the anisotropy of the microstructure, density, microhardness, and wear resistance of SLM 316L stainless steel was studied. Specimens subjected to solution + aging treatment exhibited γ austenite and α ferrite phases with lower microstrain, as determined via X-ray diffraction (XRD) analysis. Microstructure observations demonstrated that SLM 316L appears as intersecting melt pools on the XOY plane and fish scale-like melt pools on the XOZ plane. After heat treatment, the melt boundaries disappeared, carbides (M23C6) precipitated at grain boundaries and within the grains, and the microstructures coarsened and became more uniform. The microhardness and wear resistance of the XOY plane were shown to be superior to those of the XOZ plane, and the microhardness decreased following heat treatment. Compared with SLM 316L, the microhardness of the XOY and XOZ planes of the specimen subjected to solution + aging treatment decreased by 5.96% and 4.98%. The friction and wear test results revealed that the specimen after solution + aging treatment had the lowest friction coefficient and the smallest wear rate. The wear rates of specimens from the XOY and XOZ planes after solution + aging treatment were 21.1% and 27.1% lower than that of SLM 316L, exhibiting the best wear resistance.
Förderung
- National Natural Science Foundation of China
- Research Business Expenses in Inner Mongolia Autonomous Region First-Class Discipline Research Special Project
Zitieren
APA
Sun, M., Zhang, Q., Wu, J., Wang, H., Wang, X., Zhang, H., An, Y., Liu, Y., & Ma, L. (2025). Anisotropic Wear Resistance of Heat-Treated Selective Laser-Melted 316L Stainless Steel. Lubricants, 13(4), 189. https://doi.org/10.3390/lubricants13040189
Vancouver
Sun M, Zhang Q, Wu J, Wang H, Wang X, Zhang H, et al. Anisotropic Wear Resistance of Heat-Treated Selective Laser-Melted 316L Stainless Steel. Lubricants. 2025;13(4):189. doi:10.3390/lubricants13040189
BibTeX
@article{Sun2025,
author = {Sun, Menghui and Zhang, Qianqian and Wu, Jinxiu and Wang, Hao and Wang, Xu and Zhang, Hao and An, Yinong and Liu, Yujie and Ma, Long},
title = {Anisotropic Wear Resistance of Heat-Treated Selective Laser-Melted 316L Stainless Steel},
journal = {Lubricants},
year = {2025},
volume = {13},
number = {4},
pages = {189},
doi = {10.3390/lubricants13040189}
}
EUVIMED