Reactive Extrusion Additive Manufacturing with Continuous Fiber Reinforcement: Process Development and Composite Characterization
Journal of Manufacturing and Materials Processing · 02.11.2026 · 10 (11) · 472
DOI: 10.3390/jmmp10110472 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Manufacturing and Materials Processing, online erschienen am 02.11.2026. Verfasst von Kody Andrew Neu und 4 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: US Army Ground Vehicle Systems Center.
Abstract (Originalsprache)
Utilizing reactive extrusion additive manufacturing (REAM) to produce composite parts is a relatively unexplored area of research. The introduction and effectiveness of continuous fiber reinforcement in additive manufacturing requires a delicate balance of process parameters, including line spacing, layer height, deposition rate, and nozzle design. This study established the baseline parameters needed to produce REAM composite samples using two two-part reactive polymer resin systems and two reinforcing fibers. A venturi nozzle with internal agitation nodes was developed to introduce the continuous fiber to the REAM process and improve fiber wet-out. Material characterization revealed tensile modulus and strength increases of 1219% and 276%, respectively, for a composite containing 8.29% glass fiber—the highest fiber volume percentage achieved in this study. A basalt composite with 2.19% fiber and 13.2% voids by volume—the highest void percentage found—had a flexural strength of 35.3 MPa, a 233% increase compared to its unfilled resin system. Material characteristics, including fiber tow size, fiber sizing, resin viscosity, and resin gel time, contributed to overall composite and process performance. These findings and the processes developed in this study provide a foundation for future research aimed at improving the quality, performance, and complexity of REAM composites.
Förderung
- US Army Ground Vehicle Systems Center
Zitieren
APA
Neu, K. A., Swinehart, G., Workin, R., Gibbon, L. R., & Ulven, C. A. (2026). Reactive Extrusion Additive Manufacturing with Continuous Fiber Reinforcement: Process Development and Composite Characterization. Journal of Manufacturing and Materials Processing, 10(11), 472. https://doi.org/10.3390/jmmp10110472
Vancouver
Neu KA, Swinehart G, Workin R, Gibbon LR, Ulven CA. Reactive Extrusion Additive Manufacturing with Continuous Fiber Reinforcement: Process Development and Composite Characterization. Journal of Manufacturing and Materials Processing. 2026;10(11):472. doi:10.3390/jmmp10110472
BibTeX
@article{Neu2026,
author = {Neu, Kody Andrew and Swinehart, Gavin and Workin, Rachel and Gibbon, Luke R. and Ulven, Chad A.},
title = {Reactive Extrusion Additive Manufacturing with Continuous Fiber Reinforcement: Process Development and Composite Characterization},
journal = {Journal of Manufacturing and Materials Processing},
year = {2026},
volume = {10},
number = {11},
pages = {472},
doi = {10.3390/jmmp10110472}
}
EUVIMED