EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Dynamic Modeling and Chatter Stability of a Robotic Milling Manipulator Considering the Flexibility of Arms and Joints

Chao Chen, Jingjun Yu, Yiqing Yang, Wenjing Wu, Wenshuo Ma

Journal of Manufacturing and Materials Processing · 14.06.2026 · 10 (6) · 206

DOI: 10.3390/jmmp10060206 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Manufacturing and Materials Processing, online erschienen am 14.06.2026. Verfasst von Chao Chen und 4 weiteren Autor:innen. Die Arbeit nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Jiangxi Provincial Natural Science Foundation, State Key Laboratory of High-end Heavy-load Robots, Fundamental Research Funds for the Central Universities.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The application of robotic milling manipulators demonstrates a promising method for the efficient manufacturing of large-scale structures. However, the cutting accuracy and efficiency of milling robots are predominantly subjected to their low stiffness, which may easily cause chatter during machining. Accurate prediction of chatter stability for robots is of practical importance and is challenging. This paper develops a dynamic model of flexible link elements by considering link flexibility and joint torsional deformation and then constructs a multi-link flexible coupled dynamic model using the receptance coupling substructure analysis (RCSA) method. Subsequently, the equivalent dynamic parameters are identified via the particle swarm optimization (PSO) algorithm. On this basis, the end-effector frequency response functions (FRFs) of the robot under different poses are predicted, and the stability lobe diagram (SLD) for milling is generated based on chatter theory. Finally, the predicted FRFs and stability regions are validated through modal tests and milling experiments. Experimental results demonstrate that the proposed model can predict the end-effector dynamic characteristics and chatter occurrence conditions under different poses, confirming its effectiveness in the analysis of milling chatter stability. Quantitative validation yields a maximum error of 3% for predicted first-order modal frequencies and relative modal amplitude errors below 10%, with experimentally confirmed critical depths of cut of 0.1–0.2 mm at 3000 rev/min and 0.5–0.6 mm at 5000 rev/min.

Förderung

  • Jiangxi Provincial Natural Science Foundation
  • State Key Laboratory of High-end Heavy-load Robots
  • Fundamental Research Funds for the Central Universities

Zitieren

APA

Chen, C., Yu, J., Yang, Y., Wu, W., & Ma, W. (2026). Dynamic Modeling and Chatter Stability of a Robotic Milling Manipulator Considering the Flexibility of Arms and Joints. Journal of Manufacturing and Materials Processing, 10(6), 206. https://doi.org/10.3390/jmmp10060206

Vancouver

Chen C, Yu J, Yang Y, Wu W, Ma W. Dynamic Modeling and Chatter Stability of a Robotic Milling Manipulator Considering the Flexibility of Arms and Joints. Journal of Manufacturing and Materials Processing. 2026;10(6):206. doi:10.3390/jmmp10060206

BibTeX
@article{Chen2026,
  author = {Chen, Chao and Yu, Jingjun and Yang, Yiqing and Wu, Wenjing and Ma, Wenshuo},
  title = {Dynamic Modeling and Chatter Stability of a Robotic Milling Manipulator Considering the Flexibility of Arms and Joints},
  journal = {Journal of Manufacturing and Materials Processing},
  year = {2026},
  volume = {10},
  number = {6},
  pages = {206},
  doi = {10.3390/jmmp10060206}
}
Kostenlos starten →