EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Which Signal-to-Noise Ratio Is Used in Simulations? Transmitter Side versus Receiver Side: A Study Based on Long Term Evolution Downlink Transmission

Yu-Sun Liu, Shingchern D. You, Zong-Ru Jhan, Meng-Fan Li

Information · 13.08.2024 · 15 (8) · 479

DOI: 10.3390/info15080479 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Information, online erschienen am 13.08.2024. Verfasst von Yu-Sun Liu und 3 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science and Technology Council, Taiwan.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The bit error rate (BER) in relation to the signal-to-noise ratio (SNR) serves as a widely recognized metric for assessing the performance of communication systems. The concept of SNR is so integral that many existing studies presume its definition to be understood, often omitting the specifics of its calculation in their simulations. Notably, the computation of SNR from the perspective of the transmitter yields distinct behaviors and outcomes compared to that from the receiver’s side, particularly when the channel encompasses more than mere noise. Typically, research papers utilize the transmitter-side (or ensemble-average) SNR to benchmark the BER performance across various methodologies. Conversely, the receiver-side (or short-term) SNR becomes pertinent when prioritizing the receiver’s performance. In the context of simulating the long-term evolution (LTE) downlink, applying both SNR calculation approaches reveals that the receiver-side SNR not only produces a significantly lower BER compared to the transmitter-side SNR but also alters the relative BER performance rankings among the channel models tested. It is deduced that while the transmitter-side SNR is apt for broad performance comparisons, it falls short in thoroughly examining the BER behavior of a receiver across varying SNR scenarios. Therefore, the transmitter-side SNR is useful when comparing the performance of the simulated system with other studies. Conversely, if the primary concern is the actual BER performance of the receiver, the receiver-side SNR could provide a more accurate performance assessment.

Förderung

  • National Science and Technology Council, Taiwan

Zitieren

APA

Liu, Y., You, S. D., Jhan, Z., & Li, M. (2024). Which Signal-to-Noise Ratio Is Used in Simulations? Transmitter Side versus Receiver Side: A Study Based on Long Term Evolution Downlink Transmission. Information, 15(8), 479. https://doi.org/10.3390/info15080479

Vancouver

Liu Y, You SD, Jhan Z, Li M. Which Signal-to-Noise Ratio Is Used in Simulations? Transmitter Side versus Receiver Side: A Study Based on Long Term Evolution Downlink Transmission. Information. 2024;15(8):479. doi:10.3390/info15080479

BibTeX
@article{Liu2024,
  author = {Liu, Yu-Sun and You, Shingchern D. and Jhan, Zong-Ru and Li, Meng-Fan},
  title = {Which Signal-to-Noise Ratio Is Used in Simulations? Transmitter Side versus Receiver Side: A Study Based on Long Term Evolution Downlink Transmission},
  journal = {Information},
  year = {2024},
  volume = {15},
  number = {8},
  pages = {479},
  doi = {10.3390/info15080479}
}
Kostenlos starten →