EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Influence of Strain Rate Variations on Bonded-Particle Models in PFC

Ömer Ündül, Enes Zengin

Geotechnics · 06.12.2025 · 5 (4) · 82

DOI: 10.3390/geotechnics5040082 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Geotechnics, online erschienen am 06.12.2025. Verfasst von Ömer Ündül und 1 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: TÜBİTAK Project, Kütahya Dumlupınar University BAP Project.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Understanding the strain rate behavior of rock materials is key to geomechanical engineering. However, in numerical tools such as the Particle Flow Code (PFC), the chosen bonded-particle contact model also fundamentally dictates the mechanical response. A systematic comparison of how quasi-static strain rates affect different contact models, Parallel-Bonded (PBM), Soft-Bonded (SBM), and Flat-Jointed (FJM), using a common calibration baseline, has been lacking. This study addresses that gap by first calibrating all three models against identical laboratory data from the siltstone of Paleozoic-aged Trakya formation in Cebeciköy-Istanbul, Türkiye. Subsequently, numerical uniaxial loading simulations were conducted on the calibrated models at three distinct quasi-static strain rates (0.01, 0.005, and 0.001 s−1) to compare their stress–strain response, crack evolution, and failure patterns. The results demonstrate that while the initial elastic stiffness was largely insensitive to the applied strain rates across all models, the post-peak behavior and failure mechanism remained fundamentally distinct and model dependent. PBM consistently produced an abrupt, localized brittle failure, SBM exhibited more gradual softening with distributed tensile damage, and FJM displayed the most widespread, mixed-mode failure pattern. It is concluded that within the quasi-static loading conditions, the intrinsic formulation of the chosen contact model is a more dominant factor in controlling the failure style, damage localization, and post-peak characteristics than the specific strain rate applied.

Förderung

  • TÜBİTAK Project
  • Kütahya Dumlupınar University BAP Project

Zitieren

APA

Ündül, Ö., & Zengin, E. (2025). The Influence of Strain Rate Variations on Bonded-Particle Models in PFC. Geotechnics, 5(4), 82. https://doi.org/10.3390/geotechnics5040082

Vancouver

Ündül Ö, Zengin E. The Influence of Strain Rate Variations on Bonded-Particle Models in PFC. Geotechnics. 2025;5(4):82. doi:10.3390/geotechnics5040082

BibTeX
@article{ndl2025,
  author = {Ündül, Ömer and Zengin, Enes},
  title = {The Influence of Strain Rate Variations on Bonded-Particle Models in PFC},
  journal = {Geotechnics},
  year = {2025},
  volume = {5},
  number = {4},
  pages = {82},
  doi = {10.3390/geotechnics5040082}
}
Kostenlos starten →