A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator
Energies · 20.08.2024 · 17 (16) · 4147
DOI: 10.3390/en17164147 ↗Kurz gefasst
Fachartikel in der Zeitschrift Energies, online erschienen am 20.08.2024. Verfasst von De Tian und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and Technology of the People’s Republic of China.
Abstract (Originalsprache)
The design optimization of a direct-drive permanent magnet synchronous generator (DDPMSG) is of great significance for wind turbines because of its unique advantages. This paper proposes a two-stage model to realize multi-objective design optimization for a 6 MW DDPMSG. In the first stage, a surrogate optimized response surface model based on an improved sparrow search algorithm (ISSA) was established for modeling the cogging torque and generator efficiency. In the second-stage model, a multi-objective optimization model is proposed to optimize the cogging torque and generator efficiency of the DDPMSG. Finally, the proposed two-stage model was used for a 6 MW DDPMSG design optimization, and the simulation results demonstrated the superiority and rationality of the proposed model. In the first-stage model, the proposed surrogate model based on the ISSA had a better modeling accuracy and lower errors. Compared with traditional response surface models and correlation analysis models, the proposed optimized surrogate model reduced errors in the cogging torque by 34.63% and 42.97%, respectively, while the errors in the efficiency models were reduced by 12.92% and 60.78%, respectively, which indicates the superiority of the first-stage model. In the second stage, compared with the single-objective optimization model, the multi-objective optimization model achieved a trade-off optimization between the cogging torque and the efficiency. Compared with the cogging torque optimization model, the proposed model optimized the efficiency by 101.41%. Compared with the efficiency optimization model, the proposed model reduced the cogging torque by 16.67%. These results verified the superiority and rationality of the second-stage model.
Förderung
- Ministry of Science and Technology of the People’s Republic of China
Zitieren
APA
Tian, D., Wu, X., Meng, H., & Su, Y. (2024). A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator. Energies, 17(16), 4147. https://doi.org/10.3390/en17164147
Vancouver
Tian D, Wu X, Meng H, Su Y. A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator. Energies. 2024;17(16):4147. doi:10.3390/en17164147
BibTeX
@article{Tian2024,
author = {Tian, De and Wu, Xiaoxuan and Meng, Huiwen and Su, Yi},
title = {A Two-Stage Multi-Objective Design Optimization Model for a 6 MW Direct-Drive Permanent Magnet Synchronous Generator},
journal = {Energies},
year = {2024},
volume = {17},
number = {16},
pages = {4147},
doi = {10.3390/en17164147}
}
EUVIMED