EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Practical RIS Design: Scalability, Tolerance, and Calibration

Ic-Pyo Hong

Electronics · 31.10.2026 · 15 (21) · 5055

DOI: 10.3390/electronics15215055 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronics, online erschienen am 31.10.2026. Verfasst von Ic-Pyo Hong. Die Arbeit nennt 61 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Priority Research Center Program through the National Research Foundation of Korea, Korea government.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Reconfigurable intelligent surfaces (RISs) require joint choices of tuning element, addressing, tolerance, and calibration. This paper presents a conditional co-design framework evaluated analytically and through reproducible numerical experiments. A perimeter-capacity ratio screens specified edge-escape architectures while distinguishing external wiring from independent per-cell control. Its illustrative one-square-meter boundary depends on line multiplicity, routing pitch, and usable layers and does not prove PCB unroutability. A coupled tolerance study compares ensemble variance, realization RMS, and piston/tilt-removed RMS. Spatial structure changes sidelobes and pointing, while apparent peak-gain recovery with correlation partly depends on normalization. Scan-specific checks correct a phase-datum sensitivity in two-bit quantization. A balanced four-phase power protocol separates complex state contrasts from an anchored physical cell lookup table. Decision-margin tests replace a universal coupling threshold; joint noise and multipath experiments state the reference, rank, and stationarity conditions. Short delay-line cells are distinguished from full-aperture true-time-delay control. A revised 28 GHz architecture comparison includes serial per-cell storage, uncertainty intervals, and requirement sensitivity. Multiple candidates satisfy the pattern, latency, and perimeter screens under stated command laws; physical stack-up, non-linear tuning, and stationarity still require hardware-specific verification. The framework supports traceable design comparisons rather than universal frequency, resolution, or manufacturing limits.

Förderung

  • Priority Research Center Program through the National Research Foundation of Korea
  • Korea government

Zitieren

APA

Hong, I. (2026). Practical RIS Design: Scalability, Tolerance, and Calibration. Electronics, 15(21), 5055. https://doi.org/10.3390/electronics15215055

Vancouver

Hong I. Practical RIS Design: Scalability, Tolerance, and Calibration. Electronics. 2026;15(21):5055. doi:10.3390/electronics15215055

BibTeX
@article{Hong2026,
  author = {Hong, Ic-Pyo},
  title = {Practical RIS Design: Scalability, Tolerance, and Calibration},
  journal = {Electronics},
  year = {2026},
  volume = {15},
  number = {21},
  pages = {5055},
  doi = {10.3390/electronics15215055}
}
Kostenlos starten →