Torque Coordination Control for Dual-Drive-Axle Electric Commercial Vehicles Under Wheel-Speed Signal Loss
Electronics · 01.08.2026 · 15 (15) · 3398
DOI: 10.3390/electronics15153398 ↗Kurz gefasst
Fachartikel in der Zeitschrift Electronics, online erschienen am 01.08.2026. Verfasst von Hsin Guan und 4 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Key Research and Development Program of China, Foundation of State Key Laboratory of Automotive Simulation and Control, Sichuan Science and Technology Program.
Abstract (Originalsprache)
For 6 × 4 dual-drive-axle battery electric tractors subject to intermediate-axle wheel-speed signal loss, the drive-wheel slip state is difficult to determine under adhesion-limited driving conditions, which can readily lead to drive torque distribution mismatch between the intermediate and rear axles and excessive slip of the intermediate-axle drive wheels. To address the above problems, this paper proposes a torque coordination control method for dual-drive-axle battery electric commercial vehicles. First, a drive-axle slip ratio is constructed based on the motor speed of the drive axle to enable axle-level characterization of the drive-axle slip state under wheel-speed signal loss. Second, the drive-axle slip state is identified using the local variation relationship between the ground driving force and the drive-axle slip ratio, and the reference slip ratio of the drive axle and the wheel-end transmissible torque limit are determined. Then, a hierarchical torque coordination control method is established. In the upper layer, with convergence of the drive-axle slip ratios of the intermediate and rear axles as the objective, the wheel-end transmissible torque limit is introduced for inter-axle drive torque distribution and constraint handling. In the lower layer, super-twisting sliding mode control is employed to perform anti-slip correction on the target torque of the drive axle. Finally, the proposed method is validated in a TruckSim/Simulink co-simulation environment. The results show that, under drive-wheel speed signal loss, the proposed method can achieve reasonable drive torque distribution between the intermediate and rear axles under adhesion-limited driving conditions, suppress excessive slip of the drive axles, and improve the smoothness of the vehicle longitudinal response.
Förderung
- National Key Research and Development Program of China
- Foundation of State Key Laboratory of Automotive Simulation and Control
- Sichuan Science and Technology Program
Zitieren
APA
Guan, H., Xue, P., Zhan, J., Jin, H., & Zhang, M. (2026). Torque Coordination Control for Dual-Drive-Axle Electric Commercial Vehicles Under Wheel-Speed Signal Loss. Electronics, 15(15), 3398. https://doi.org/10.3390/electronics15153398
Vancouver
Guan H, Xue P, Zhan J, Jin H, Zhang M. Torque Coordination Control for Dual-Drive-Axle Electric Commercial Vehicles Under Wheel-Speed Signal Loss. Electronics. 2026;15(15):3398. doi:10.3390/electronics15153398
BibTeX
@article{Guan2026,
author = {Guan, Hsin and Xue, Pengcheng and Zhan, Jun and Jin, Hao and Zhang, Mingwei},
title = {Torque Coordination Control for Dual-Drive-Axle Electric Commercial Vehicles Under Wheel-Speed Signal Loss},
journal = {Electronics},
year = {2026},
volume = {15},
number = {15},
pages = {3398},
doi = {10.3390/electronics15153398}
}
EUVIMED