EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Development and Evaluation of a Piezoelectret Insole for Energy Harvesting Applications

Marcio L. M. Amorim, Gabriel Augusto Ginja, Melkzedekue de Moraes Alcântara Calabrese Moreira, Oswaldo Hideo Ando Junior, Adriano Almeida Goncalves Siqueira, Vitor Monteiro, José A. Afonso, João P. P. do Carmo, João L. Afonso

Electronics · 30.10.2025 · 14 (21) · 4254

DOI: 10.3390/electronics14214254 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronics, online erschienen am 30.10.2025. Verfasst von Marcio L. M. Amorim und 8 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: CAPES, National Council for Scientific and Technological Development, FAPESP.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work presents the development and experimental validation of a low-cost, piezoelectret-based energy harvesting system integrated into a custom insole, as a promising alternative for future self-powered wearable electronics. The design utilizes eight thermoformed Teflon piezoelectrets, strategically positioned in high-impact regions (heel and forefoot), to convert footstep-induced mechanical motion into electrical energy. The sensors, fabricated using Fluorinated Ethylene Propylene (FEP) and Polytetrafluoroethylene (PTFE) layers via thermal pressing and aluminum sputtering, were connected in parallel to enhance signal consistency and robustness. A solenoid-actuated mechanical test rig was developed to simulate human gait under controlled conditions. The system consistently produced voltage pulses with peaks up to 13 V and durations exceeding ms, even under limited-force loading (10 kgf). Signal analysis confirmed repeatable waveform characteristics, and a Delon voltage multiplier enabled partial conversion into usable DC output. While not yet optimized for maximum efficiency, the proposed setup demonstrates the feasibility of using piezoelectrets for energy harvesting. Its simplicity, scalability, and low cost support its potential for future integration in applications such as fitness tracking, health monitoring, and GPS ultimately contributing to the development of autonomous, self-powered smart footwear systems. It is important to emphasize that the present study is a proof-of-concept validated exclusively under controlled laboratory conditions using a mechanical gait simulator. Future work will address real-time insole application tests with human participants.

Förderung

  • CAPES
  • National Council for Scientific and Technological Development
  • FAPESP

Zitieren

APA

Amorim, M. L. M., Ginja, G. A., Moreira, M. D. M. A. C., Junior, O. H. A., Siqueira, A. A. G., Monteiro, V., Afonso, J. A., Carmo, J. P. P. D., & Afonso, J. L. (2025). Development and Evaluation of a Piezoelectret Insole for Energy Harvesting Applications. Electronics, 14(21), 4254. https://doi.org/10.3390/electronics14214254

Vancouver

Amorim MLM, Ginja GA, Moreira MDMAC, Junior OHA, Siqueira AAG, Monteiro V, et al. Development and Evaluation of a Piezoelectret Insole for Energy Harvesting Applications. Electronics. 2025;14(21):4254. doi:10.3390/electronics14214254

BibTeX
@article{Amorim2025,
  author = {Amorim, Marcio L. M. and Ginja, Gabriel Augusto and Moreira, Melkzedekue de Moraes Alcântara Calabrese and Junior, Oswaldo Hideo Ando and Siqueira, Adriano Almeida Goncalves and Monteiro, Vitor and Afonso, José A. and Carmo, João P. P. do and Afonso, João L.},
  title = {Development and Evaluation of a Piezoelectret Insole for Energy Harvesting Applications},
  journal = {Electronics},
  year = {2025},
  volume = {14},
  number = {21},
  pages = {4254},
  doi = {10.3390/electronics14214254}
}
Kostenlos starten →