EUVIMEDSkopri EUVIMED
Open access · CC BY 4.0

Analysis and Design of Class-D Outphasing Power Amplifier with Non-Isolating Balun Combiner

Jiyun Bae, Munsu Jeong, Sangjin Yoo, Ilku Nam, Ockgoo Lee

Electronics · 2025-05-28 · 14 (11) · 2196

DOI: 10.3390/electronics14112196 ↗

At a glance

Journal article in Electronics, published online on 2025-05-28. Written by Jiyun Bae and 4 co-authors. Cited 4 times so far (Crossref); 31 references. The full text is freely available (open access, CC BY 4.0). Funded by: the Institute of Information and communications Technology Planning and Evaluation (IITP), the Korea government (MSIT), the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT).

AstrattDettalji biblijografiċiCiteRelated studies

Abstract (original language)

This paper presents a class-D outphasing power amplifier (PA) that incorporates a non-isolating balun combiner employing a 180° phase shift. Both isolating and non-isolating outphasing combiners are analyzed for signal restoration and combining efficiency. The proposed non-isolating balun combiner employing the 180° phase shift was experimentally evaluated and compared with a commercial isolating Wilkinson combiner. When two constant-envelope signals derived from a 10 MHz long-term evolution (LTE) signal are applied to the inputs of the outphasing combiners, both combiners demonstrate successful signal reconstruction. The measured adjacent channel leakage ratios (ACLRs) are −47 dBc for the Wilkinson combiner and −46 dBc for the proposed balun combiner. At 6 dB power back-off (PBO), the proposed balun combiner achieves a combining efficiency of 85.1%, representing an improvement of nearly 60% over the Wilkinson combiner. With a center frequency of 650 MHz, targeting 5G FR1 applications, a class-D outphasing PA was designed in a 28 nm CMOS process using the measured S-parameter data from both outphasing combiners. Simulation results show that the class-D outphasing PA incorporating the proposed balun combiner achieves a peak drain efficiency (DE) of 82.9% with an output power of 17.7 dBm. At 6 dB PBO, the DE reaches 61%, which is approximately 37% higher than that of the outphasing PA using the Wilkinson combiner. Moreover, the designed outphasing PA supports broadband operation over the 360–860 MHz range.

Funding

  • the Institute of Information and communications Technology Planning and Evaluation (IITP), the Korea government (MSIT)
  • the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT)

Cite

APA

Bae, J., Jeong, M., Yoo, S., Nam, I., & Lee, O. (2025). Analysis and Design of Class-D Outphasing Power Amplifier with Non-Isolating Balun Combiner. Electronics, 14(11), 2196. https://doi.org/10.3390/electronics14112196

Vancouver

Bae J, Jeong M, Yoo S, Nam I, Lee O. Analysis and Design of Class-D Outphasing Power Amplifier with Non-Isolating Balun Combiner. Electronics. 2025;14(11):2196. doi:10.3390/electronics14112196

BibTeX
@article{Bae2025,
  author = {Bae, Jiyun and Jeong, Munsu and Yoo, Sangjin and Nam, Ilku and Lee, Ockgoo},
  title = {Analysis and Design of Class-D Outphasing Power Amplifier with Non-Isolating Balun Combiner},
  journal = {Electronics},
  year = {2025},
  volume = {14},
  number = {11},
  pages = {2196},
  doi = {10.3390/electronics14112196}
}
Start for free →