EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Temperature-Controlled Molten-Salt Treatment of Co-Coated Ni Substrates to Form Porous Electrodes for Alkaline Hydrogen and Oxygen Evolution Reactions

Dawid Kutyła, Michihisa Fukumoto, Ryuu Takahashi, Katarzyna Skibińska, Piotr Palimąka, Piotr Żabiński

Coatings · 04.11.2026 · 16 (11) · 1313

DOI: 10.3390/coatings16111313 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 04.11.2026. Verfasst von Dawid Kutyła und 5 weiteren Autor:innen. Die Arbeit nennt 50 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Yashima Environment Technology Foundation, Excellence initiative—research university” programme of the AGH University of Krakow.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this work, porous coatings were obtained by Co electrodeposition on Ni, followed by Al deposition and anodic dissolution in a NaCl–KCl–AlF3 melt at 750, 825 and 900 °C. The same Co-coated Ni precursor, applied potentials and 3600 s Al-deposition time were used at all temperatures; the recorded anodic durations and transferred charges differed. SEM observations showed a change from a fine sponge-like surface to a coarser porous network. The estimated layer thicknesses were 8–12, 32–55 and 50–65 µm, respectively. The main XRD reflections were consistent with an fcc metallic phase in Co-rich material, with possible overlapping signals from Ni. Weak additional reflections were tentatively associated with Al-containing phases, but their identity was not confirmed. The highest apparent capacitance estimate was obtained at 825 °C. In 1 M NaOH, the lowest HER overpotentials among the treated electrodes were registered for the 900 °C sample: 109 and 494 mV after 2 h at −10 and −100 mA cm−2. For OER, the lowest apparent Tafel slope was obtained at 750 °C, while the lowest end-of-test overpotentials were obtained at 900 °C. Unmodified Ni showed higher anodic currents in part of the polarisation range, so the treatment did not give a general improvement in OER compared with Ni. No post-measurement iR correction was applied. The measured electrodes showed different trends in morphology, apparent capacitance and HER/OER response; statistical significance and between-electrode reproducibility were not established.

Förderung

  • Yashima Environment Technology Foundation
  • Excellence initiative—research university” programme of the AGH University of Krakow

Zitieren

APA

Kutyła, D., Fukumoto, M., Takahashi, R., Skibińska, K., Palimąka, P., & Żabiński, P. (2026). Temperature-Controlled Molten-Salt Treatment of Co-Coated Ni Substrates to Form Porous Electrodes for Alkaline Hydrogen and Oxygen Evolution Reactions. Coatings, 16(11), 1313. https://doi.org/10.3390/coatings16111313

Vancouver

Kutyła D, Fukumoto M, Takahashi R, Skibińska K, Palimąka P, Żabiński P. Temperature-Controlled Molten-Salt Treatment of Co-Coated Ni Substrates to Form Porous Electrodes for Alkaline Hydrogen and Oxygen Evolution Reactions. Coatings. 2026;16(11):1313. doi:10.3390/coatings16111313

BibTeX
@article{Kutya2026,
  author = {Kutyła, Dawid and Fukumoto, Michihisa and Takahashi, Ryuu and Skibińska, Katarzyna and Palimąka, Piotr and Żabiński, Piotr},
  title = {Temperature-Controlled Molten-Salt Treatment of Co-Coated Ni Substrates to Form Porous Electrodes for Alkaline Hydrogen and Oxygen Evolution Reactions},
  journal = {Coatings},
  year = {2026},
  volume = {16},
  number = {11},
  pages = {1313},
  doi = {10.3390/coatings16111313}
}
Kostenlos starten →