Paint Removal Performance and Sub-Surface Microstructural Evolution of Ti6Al4V Alloy Using Different Process Parameters of Continuous Laser Cleaning
Coatings · 06.08.2025 · 15 (8) · 916
DOI: 10.3390/coatings15080916 ↗Kurz gefasst
Fachartikel in der Zeitschrift Coatings, online erschienen am 06.08.2025. Verfasst von Haoye Zeng und 6 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Key Research and Development Program of China, Doctoral research startup fund at University of South China, Hengyang City research project of Science and Technology Bureau.
Abstract (Originalsprache)
Laser cleaning technology has been increasingly applied in the removal of damaged protective coatings from aircraft components due to its environmental friendliness and high efficiency. Appropriate laser cleaning process parameters improve cleaning efficiency while preventing substrate damage. In this study, a Gaussian continuous-wave laser was used to remove the 120 μm coating on the surface of Ti6Al4V alloy. The influence of laser power (100 W to 200 W) and scanning speed (520 mm/min to 610 mm/min) on the paint removal effect was explored based on paint removal rate, surface roughness, microstructural evolution, and the hardness’ change in the direction of heat transfer. The results reveal that optimal paint removal parameters are achieved at a laser power of 100 W with a scanning speed of 550 mm/min. The surface roughness of the sample after paint removal (55 nm) is similar to that of the original substrate (56 nm). Through EBSD analysis, the influence of laser thermal accumulation on the microstructure of the substrate is relatively small. The average hardness of the cross-section after cleaning was 347 HV, which was only 3.41% higher than that of the original substrate. This confirms that parameter-controlled laser cleaning can effectively remove ~120 μm thick paint layers without inflicting damage on the substrate.
Förderung
- National Key Research and Development Program of China
- Doctoral research startup fund at University of South China
- Hengyang City research project of Science and Technology Bureau
- Research Project Funded by the Education Department of Hunan Province
- Natural Science Foundation of Hunan Province
Zitieren
APA
Zeng, H., Li, B., Hu, L., Zhang, Y., Li, R., Zhou, C., & Chen, P. (2025). Paint Removal Performance and Sub-Surface Microstructural Evolution of Ti6Al4V Alloy Using Different Process Parameters of Continuous Laser Cleaning. Coatings, 15(8), 916. https://doi.org/10.3390/coatings15080916
Vancouver
Zeng H, Li B, Hu L, Zhang Y, Li R, Zhou C, et al. Paint Removal Performance and Sub-Surface Microstructural Evolution of Ti6Al4V Alloy Using Different Process Parameters of Continuous Laser Cleaning. Coatings. 2025;15(8):916. doi:10.3390/coatings15080916
BibTeX
@article{Zeng2025,
author = {Zeng, Haoye and Li, Biwen and Hu, Liangbin and Zhang, Yun and Li, Ruiqing and Zhou, Chaochao and Chen, Pinghu},
title = {Paint Removal Performance and Sub-Surface Microstructural Evolution of Ti6Al4V Alloy Using Different Process Parameters of Continuous Laser Cleaning},
journal = {Coatings},
year = {2025},
volume = {15},
number = {8},
pages = {916},
doi = {10.3390/coatings15080916}
}
EUVIMED