EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Comparative Analysis of Cutting Forces in CNC Milling of MDF: The Role of Tool Coatings, Cutting Speed, and Feed Per Tooth

Luďka Hanincová, Jiří Procházka, Vít Novák

Coatings · 23.08.2024 · 14 (9) · 1085

DOI: 10.3390/coatings14091085 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 23.08.2024. Verfasst von Luďka Hanincová und 2 weiteren Autor:innen. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Specific University Research Fund, European Union.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the influence of various tool coatings, cutting speeds, and feed per tooth values on cutting forces during the CNC milling of Medium Density Fiberboard (MDF). The coatings tested include reference, TripleSi, Hyperlox, DLC, and lapped coatings. Experiments were conducted using an SCM Morbidelli m100 CNC milling machine under controlled conditions. Cutting speeds were set at 8, 10, and 12 m/s, while feed per tooth values were varied at 0.1, 0.2, and 0.3 mm. Cutting forces were measured using a three-axis piezoelectric dynamometer Kistler, and the data were analyzed to determine the impact of these variables on cutting performance. The results revealed that while cutting speed had a minimal effect on cutting forces, feed per tooth significantly influenced them, with higher values of feed per tooth leading to increased forces. Among the coatings, lapped and TripleSi exhibited the lowest cutting forces, whereas DLC showed the highest. Statistical analysis, including ANOVA and Scheffé tests, confirmed the significant differences between the coatings and highlighted the superior performance of the lapped and TripleSi coatings in reducing cutting forces.

Förderung

  • Specific University Research Fund
  • European Union

Zitieren

APA

Hanincová, L., Procházka, J., & Novák, V. (2024). Comparative Analysis of Cutting Forces in CNC Milling of MDF: The Role of Tool Coatings, Cutting Speed, and Feed Per Tooth. Coatings, 14(9), 1085. https://doi.org/10.3390/coatings14091085

Vancouver

Hanincová L, Procházka J, Novák V. Comparative Analysis of Cutting Forces in CNC Milling of MDF: The Role of Tool Coatings, Cutting Speed, and Feed Per Tooth. Coatings. 2024;14(9):1085. doi:10.3390/coatings14091085

BibTeX
@article{Hanincov2024,
  author = {Hanincová, Luďka and Procházka, Jiří and Novák, Vít},
  title = {Comparative Analysis of Cutting Forces in CNC Milling of MDF: The Role of Tool Coatings, Cutting Speed, and Feed Per Tooth},
  journal = {Coatings},
  year = {2024},
  volume = {14},
  number = {9},
  pages = {1085},
  doi = {10.3390/coatings14091085}
}
Kostenlos starten →