Preliminary Experimental Study on the Flexural Behavior of High-Strength Castellated Steel–UHPC Composite Beams with Hinged-Bolt Shear Connectors
Buildings · 28.08.2026 · 16 (17) · 3445
DOI: 10.3390/buildings16173445 ↗Kurz gefasst
Fachartikel in der Zeitschrift Buildings, online erschienen am 28.08.2026. Verfasst von Shiqiang Feng und 7 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Key R&D Program of Shaanxi Province, National Program on Key R&D Project of China.
Abstract (Originalsprache)
High-strength steel–ultra-high-performance concrete (UHPC) composite beams provide an efficient solution for lightweight and high-capacity building structures. This study presents a preliminary experimental investigation on the flexural behavior of three high-strength castellated steel–UHPC composite beam configurations employing hinged-bolt shear connectors. This connector type had previously been validated only at the component level and was applied here for the first time in high-strength castellated steel–UHPC composite beams. The three beams were tested under positive bending: a reference specimen with a full-depth cast-in-place UHPC slab and dispersed connectors (CC-DHB), a prefabricated specimen with a C100 precast slab, dispersed connectors, and local UHPC connection regions (PC-DHB), and a prefabricated specimen with a C100 precast slab, grouped connectors, and local UHPC connection regions (PC-GHB). The failure mode, load–deflection response, ductility, interface slip, strain distribution, and flexural resistance were evaluated. The results showed that all specimens exhibited flexure-dominated failure, characterized by the yielding of the steel girder and tensile reinforcement occurring first, followed by concrete crushing near the loading region. A key finding was that, although UHPC was used only in the local connection regions of the two prefabricated configurations, their peak flexural resistances were only 4.5% and 2.5% lower than that of the full-depth cast-in-place UHPC reference beam, indicating that the prefabricated beams substantially reduced UHPC use while retaining nearly the same ultimate flexural resistance as the reference beam. However, their initial stiffness and ductility factors decreased by up to 17%, while their cracking load decreased by approximately 50%. Compared with specimen PC-GHB, the initial stiffness and ductility of specimen PC-DHB increased by approximately 5%. The maximum measured interface slip before the peak load was less than 3 mm for all specimens. A preliminary sectional plastic-resistance method was also developed, and the calculated-to-tested resistance ratios ranged from 1.06 to 1.08. Further validation is required for different connector spacings, web-opening layouts, slab configurations, and shear connection degrees.
Förderung
- National Natural Science Foundation of China
- Key R&D Program of Shaanxi Province
- National Program on Key R&D Project of China
- Shandong Postdoctoral Science Foundation
Zitieren
APA
Feng, S., Yang, Y., Chen, X., Xue, Y., Yu, Y., He, J., Chen, Y., & Sun, D. (2026). Preliminary Experimental Study on the Flexural Behavior of High-Strength Castellated Steel–UHPC Composite Beams with Hinged-Bolt Shear Connectors. Buildings, 16(17), 3445. https://doi.org/10.3390/buildings16173445
Vancouver
Feng S, Yang Y, Chen X, Xue Y, Yu Y, He J, et al. Preliminary Experimental Study on the Flexural Behavior of High-Strength Castellated Steel–UHPC Composite Beams with Hinged-Bolt Shear Connectors. Buildings. 2026;16(17):3445. doi:10.3390/buildings16173445
BibTeX
@article{Feng2026,
author = {Feng, Shiqiang and Yang, Yong and Chen, Xin and Xue, Yicong and Yu, Yunlong and He, Jiuzhou and Chen, Yang and Sun, Dongde},
title = {Preliminary Experimental Study on the Flexural Behavior of High-Strength Castellated Steel–UHPC Composite Beams with Hinged-Bolt Shear Connectors},
journal = {Buildings},
year = {2026},
volume = {16},
number = {17},
pages = {3445},
doi = {10.3390/buildings16173445}
}
EUVIMED