Concurrent Topology and Orientation Optimisation of 3D-Printed Concrete Under Drucker–Prager Strength Constraints: Numerical and Experimental Validation
Buildings · 19.08.2026 · 16 (16) · 3298
DOI: 10.3390/buildings16163298 ↗Kurz gefasst
Fachartikel in der Zeitschrift Buildings, online erschienen am 19.08.2026. Verfasst von Hailong Wang und 3 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Key Research and Development Program of Zhejiang Province, Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering.
Abstract (Originalsprache)
The layer-wise deposition process of three-dimensional concrete printing (3DPC) induces anisotropic behaviour, while cementitious materials exhibit pronounced tension–compression strength asymmetry. This study develops a concurrent topology and printing-direction optimisation framework for plain 3DPC under Drucker–Prager (D–P) strength constraints. Within a solid isotropic material with penalisation (SIMP) formulation, material density and printing orientation are updated simultaneously using the Method of Moving Asymptotes (MMA). A double-angle vector-field mapping regularises the π-periodic orientation field, while element-wise D–P failure indices are aggregated into a differentiable global constraint through P-norm aggregation with adaptive scale correction. Numerical studies on a four-corner pinned plate, a T-shaped bracket and a perforated deep beam show that the strength constraint reshapes load paths, suppresses local strength violations and increases ultimate load capacity by approximately 200%, 176% and 42%, respectively, relative to compliance-based optimisation. The optimised deep-beam layouts are reconstructed, converted into continuous printing paths, fabricated and tested under three-point bending. Experimentally, the mean ultimate load increases from 8.13 to 9.54 kN, corresponding to an increase of 17.39%, while the mean displacement at peak load and pre-peak energy are 20.58% and 41.16% higher, respectively. The experimental and finite element comparisons show closely similar ultimate-load increases of 17.39% and 17.43%, respectively. The framework provides a strength-aware route from concurrent numerical optimisation to the fabrication and structural assessment of plain 3DPC components.
Förderung
- National Natural Science Foundation of China
- Key Research and Development Program of Zhejiang Province
- Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering
Zitieren
APA
Wang, H., Wu, Z., Sun, X., & Xu, Q. (2026). Concurrent Topology and Orientation Optimisation of 3D-Printed Concrete Under Drucker–Prager Strength Constraints: Numerical and Experimental Validation. Buildings, 16(16), 3298. https://doi.org/10.3390/buildings16163298
Vancouver
Wang H, Wu Z, Sun X, Xu Q. Concurrent Topology and Orientation Optimisation of 3D-Printed Concrete Under Drucker–Prager Strength Constraints: Numerical and Experimental Validation. Buildings. 2026;16(16):3298. doi:10.3390/buildings16163298
BibTeX
@article{Wang2026,
author = {Wang, Hailong and Wu, Zhennan and Sun, Xiaoyan and Xu, Quanbiao},
title = {Concurrent Topology and Orientation Optimisation of 3D-Printed Concrete Under Drucker–Prager Strength Constraints: Numerical and Experimental Validation},
journal = {Buildings},
year = {2026},
volume = {16},
number = {16},
pages = {3298},
doi = {10.3390/buildings16163298}
}
EUVIMED