EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigation into the Bearing Behavior of Bridge Pile Foundations in Complex Rock Strata: Considering the Effect of Pile Roughness

Shuqing Pan, Xiaoxiong Lin, Qingye Shi, Bai Yang

Buildings · 09.04.2026 · 16 (8) · 1486

DOI: 10.3390/buildings16081486 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Buildings, online erschienen am 09.04.2026. Verfasst von Shuqing Pan und 3 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Guangxi Young and Middle-aged Teachers’ Basic Scientific Research Ability Improvement Project.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A rock-socketed pile model load test was conducted for the renovation project of the dangerous old bridge at Shaoping Bridge. The experiment focused on the core parameter of the roughness factor (RF) of the pile body, revealing its influence on the bearing characteristics. The study delved into the load–displacement relationship, ultimate bearing capacity evolution, axial force transmission mechanism, average lateral resistance performance characteristics, and pile–soil relative displacement law of test piles in complex rock formations under different RF values. The research results indicated the following: The test pile exhibited typical brittle failure. At the moment of failure, the load at the pile head dropped abruptly, resulting in a steep drop in its load–displacement curve. Under ultimate load conditions, the average attenuation amplitudes of axial force in the four test piles decreased progressively in Rock Layer I, II, and III, measuring 26.96%, 14.86%, and 10.84%, respectively. The average side resistance distribution along the pile shaft showed a single-peak pattern, peaking in Rock Layer I. Increasing RF effectively enhanced the bearing capacity of test piles. However, a higher RF value does not necessarily yield better results, as it exhibits an inverted U-shaped relationship with bearing capacity. Under the specific conditions of this study, the highest bearing capacity among the tested RF values was observed at RF = 0.168; beyond this threshold, performance actually declined. The pile-top load was primarily shared by side resistance and end bearing resistance. Both components initially increased and then decreased with increasing RF, where the end bearing resistance accounted for 43.64~49.47% of the upper load.

Förderung

  • Guangxi Young and Middle-aged Teachers’ Basic Scientific Research Ability Improvement Project

Zitieren

APA

Pan, S., Lin, X., Shi, Q., & Yang, B. (2026). Investigation into the Bearing Behavior of Bridge Pile Foundations in Complex Rock Strata: Considering the Effect of Pile Roughness. Buildings, 16(8), 1486. https://doi.org/10.3390/buildings16081486

Vancouver

Pan S, Lin X, Shi Q, Yang B. Investigation into the Bearing Behavior of Bridge Pile Foundations in Complex Rock Strata: Considering the Effect of Pile Roughness. Buildings. 2026;16(8):1486. doi:10.3390/buildings16081486

BibTeX
@article{Pan2026,
  author = {Pan, Shuqing and Lin, Xiaoxiong and Shi, Qingye and Yang, Bai},
  title = {Investigation into the Bearing Behavior of Bridge Pile Foundations in Complex Rock Strata: Considering the Effect of Pile Roughness},
  journal = {Buildings},
  year = {2026},
  volume = {16},
  number = {8},
  pages = {1486},
  doi = {10.3390/buildings16081486}
}
Kostenlos starten →