EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

High-Speed Wire Arc Additive Manufacturing: Investigating the Influence of Heat Input, Transfer Modes and Parameter Selection

Jonah McNicol, Andrew Gorrie, Keagan De Menezes, Ryan Stevenson, Athanasios Toumpis

Applied Sciences · 17.11.2026 · 16 (22) · 11370

DOI: 10.3390/app162211370 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 17.11.2026. Verfasst von Jonah McNicol und 4 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Wire arc additive manufacturing (WAAM) offers significant potential for large-scale metallic component manufacture. However, current research shows limited investigation into the distinct effects of heat input and metal transfer mode at the high travel speeds associated with automated welding. This study investigates the effects of these variables on the deposition characteristics, microstructural evolution and mechanical properties of ER70S-6 WAAM depositions. Single-pass, multi-pass and thin-wall structures were manufactured using short-circuit and spray transfer modes. Single-pass depositions with minimal defects were produced, with lower heat input conditions generating narrower and taller beads due to reduced lateral spreading and increased cooling rates. The heat-sink effect dominated the microstructural evolution, producing comparable microstructures despite heat input variations between process parameters. During multi-pass depositions at 1000 mm/min, porosity within the top layer highlighted the limitations of short-circuit transfer with increasing travel speed. Spray transfer enabled low-defect depositions at higher travel speeds. Thin walls demonstrated the ability to build at travel speeds reaching 1600 mm/min utilising spray transfer. This study concludes that spray transfer is desirable for high-speed depositions, although parameter selection requires careful consideration to maintain practical build rates.

Zitieren

APA

McNicol, J., Gorrie, A., Menezes, K. D., Stevenson, R., & Toumpis, A. (2026). High-Speed Wire Arc Additive Manufacturing: Investigating the Influence of Heat Input, Transfer Modes and Parameter Selection. Applied Sciences, 16(22), 11370. https://doi.org/10.3390/app162211370

Vancouver

McNicol J, Gorrie A, Menezes KD, Stevenson R, Toumpis A. High-Speed Wire Arc Additive Manufacturing: Investigating the Influence of Heat Input, Transfer Modes and Parameter Selection. Applied Sciences. 2026;16(22):11370. doi:10.3390/app162211370

BibTeX
@article{McNicol2026,
  author = {McNicol, Jonah and Gorrie, Andrew and Menezes, Keagan De and Stevenson, Ryan and Toumpis, Athanasios},
  title = {High-Speed Wire Arc Additive Manufacturing: Investigating the Influence of Heat Input, Transfer Modes and Parameter Selection},
  journal = {Applied Sciences},
  year = {2026},
  volume = {16},
  number = {22},
  pages = {11370},
  doi = {10.3390/app162211370}
}
Kostenlos starten →