Waste Marble Slurry as Partial Substitution for Cement: Effect of Water-to-Cement Ratio
Applied Sciences · 26.09.2025 · 15 (19) · 10451
DOI: 10.3390/app151910451 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 26.09.2025. Verfasst von Zoi S. Metaxa und 5 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: European Regional Development Fund of the European Union.
Abstract (Originalsprache)
This study investigates the potential of waste marble slurry as a partial replacement for ordinary Portland cement, with particular emphases on the influence of the water-to-cement (w/c) ratio and the objectives of determining the effect of water content and the optimum marble slurry concentration. Cement pastes were prepared with three w/c ratios (0.3, 0.4, and 0.5) and five substitution levels of marble slurry (0%, 5%, 10%, 15%, and 20%). Workability was assessed through mini slump flow tests, while mechanical performance was evaluated via compressive and flexural mechanical tests. The initial and final setting times were also investigated. Electrical resistivity measurements, combined with X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), and scanning electron microscopy (SEM), were used to examine chemical composition and microstructure. Results showed that marble slurry behaves as an inert filler, rather than a reactive component. Its incorporation, up to 10%, significantly improves the fresh properties and mechanical performance of mixes with higher w/c ratios (0.4 and 0.5). At lower w/c ratios (0.3), strength was adversely affected due to insufficient hydration. Electrical resistivity measurements indicated that pastes with w/c = 0.5 and up to 10% slurry replacement became slightly more resistant to electrical current, whereas mixes with lower w/c ratios (0.3 and 0.4) showed only minor reductions at 5% and 10% cement substitution. SEM imaging demonstrated a denser microstructure when marble slurry was incorporated, consistent with a filler effect. Marble slurry was also found to accelerate the setting of cement pastes, an effect most evident at lower w/c ratios and higher substitution levels. Overall, the findings highlight that waste marble slurry can be effectively utilized at moderate replacement levels in cement-based materials, contributing to sustainable construction practices by reducing cement consumption and marble waste disposal.
Förderung
- European Regional Development Fund of the European Union
Zitieren
APA
Metaxa, Z. S., Koryfidou, S., Grigoriadis, L., Christodoulou, E., Ekmektsis, A., & Mitropoulos, A. C. (2025). Waste Marble Slurry as Partial Substitution for Cement: Effect of Water-to-Cement Ratio. Applied Sciences, 15(19), 10451. https://doi.org/10.3390/app151910451
Vancouver
Metaxa ZS, Koryfidou S, Grigoriadis L, Christodoulou E, Ekmektsis A, Mitropoulos AC. Waste Marble Slurry as Partial Substitution for Cement: Effect of Water-to-Cement Ratio. Applied Sciences. 2025;15(19):10451. doi:10.3390/app151910451
BibTeX
@article{Metaxa2025,
author = {Metaxa, Zoi S. and Koryfidou, Sevasti and Grigoriadis, Lazaros and Christodoulou, Effrosyni and Ekmektsis, Athanasios and Mitropoulos, Athanasios C.},
title = {Waste Marble Slurry as Partial Substitution for Cement: Effect of Water-to-Cement Ratio},
journal = {Applied Sciences},
year = {2025},
volume = {15},
number = {19},
pages = {10451},
doi = {10.3390/app151910451}
}
EUVIMED